摘要
以低速压气机试验为原型,采用二维非定常数值模拟的方法研究了轴向间距改变对低速压气机气动性能的影响。数值模拟结果显示,轴向间距减至原型间距的33%时,整机效率的提高超过了1%。该方案在除第一列静叶之外的三列叶栅中都表现出流动损失的降低,尤其在第一列动叶中最为明显。轴向间距减小带来的势流干扰增强产生非定常的扑翼现象,显著改善了第一列动叶的流动状态。适当减小轴向间距可以降低叶栅内下游叶列非定常干扰引起的损失。
Based on the experimental results of a low speed compressor, two-dimensional （2D） unsteady numerical simulation has been applied to study the performance variation of low speed compressor with different inter-blade-row gaps. The result of simulation shows that the compressor efficiency is increased by more than 1% when the axial gap is decreased to be 33% of the original gap. Except for the first static row, the flow losses in the rear three blade rows are all reduced, obviously in the first rotor row in this case. It is analyzed that the enhancement of potential disturbed flow caused by the axial gap reduction will produce an unsteady flapping wing phenomena, which improves the flow significantly in the first rotor row. The conclusion is given that properly decreasing the axial clearance can reduce the loss of downstream blade row caused by unsteady disturbances.
出处
《推进技术》
EI
CAS
CSCD
北大核心
2008年第2期199-203,共5页
Journal of Propulsion Technology
基金
国家自然科学基金(50106002)
国家"九七三"项目基金(G1999022307)
关键词
压气机
间隔
非定常流
尾流
数值仿真
Compressor
Gap
Unsteady flow
Wake
Numerical simulation
