期刊文献+

前馈功放自适应控制算法性能研究 被引量:1

Research on Adaptive Algorithm of Feedforward Power Amplifier
下载PDF
导出
摘要 对应用于射频前馈功率放大器中两种自适应控制算法——功率最小算法与相关性最小算法进行了分析论证和仿真验证,结果表明两种算法是等价的,但前者所需付出的软硬件代价远低于后者,更有利于应用于实际工程中。仿真和实验研究表明,上述算法可使功放的ACPR指标改善15dB。 Two kinds of adaptive control algorithms utilized in RF feedforward power amplifier,the minimum power algorithm and the minimum correlation algorithm,are analyzed and simulated in the paper.The results show that both of them are equivalent for the performance of the adaptive control effect.The first algorithm possesses lower complexity in software and hardware design than the latter one and could be more propitious to be used in an actual feedforward power amplifier.The simulation results show that these algorithms could conduce to improve the ACPR performance of RF power amplifier about 15dB or more.
作者 于盛 马洪
出处 《计算机仿真》 CSCD 2007年第12期320-323,共4页 Computer Simulation
基金 湖北省科技厅2006年科技攻关项目(G06)
关键词 功率放大器 前馈 自适应算法 功率最小 相关性最小 Power amplifier Feedforward Adaptive algorithm Minimum power Minimum correlation
  • 相关文献

参考文献6

  • 1J K Cavers.Adaptation Behavior of a Feedforward Amplifier Linearizer[J].IEEE Trans.Vehicular Tech.,February 1995,44(1). 被引量:1
  • 2Qian Cheng,Chen Yiyuan and Zhu Xiaowei.A 1.9GHz Adaptive Feedforward Power Amplifier[J].Microwave Journal,November 1998,41(11). 被引量:1
  • 3R H Chapman and W J Turney.Feedforward distortion cancellation circuit[J].U.S.Patent 5,0151,704,September 24,1991. 被引量:1
  • 4E Jeckeln,F M Ghannouchi and M Sawan.Adaptive digital pre-distortion for power amplifiers with real time modeling of memoryless complex gain[J].U.S.Patent6072364,June6,2000. 被引量:1
  • 5S J Grant.ADSP Controlled Adaptive Feedforward Power Amplifier Linearizer[D].M.A.Sc.Thesis,School of Engineering Science,Simon Fraser University,July 1996. 被引量:1
  • 6Ma Hong,Zhu Guangxi.Performance Requirements and Analysis for RF Receiver of PDMA Terminal[Z].Wireless Personal Communication,2004,31∶89-110. 被引量:1

同被引文献4

引证文献1

相关作者

内容加载中请稍等...

相关机构

内容加载中请稍等...

相关主题

内容加载中请稍等...

浏览历史

内容加载中请稍等...
;
使用帮助 返回顶部