摘要
采用药剂破乳－电解破乳工艺处理Ｏ／Ｗ型乳化液，药剂破乳选用聚合硫酸铁为破乳剂，破乳时最佳ｐＨ为８，聚合硫酸铁的最佳投量为１５００ｍｇ／Ｌ；电解破乳选用铁作阳极，铝作阴极，电流密度０．８６Ａ／ｄｍ￣２，极距２５ｍｍ，电解时间３ｈ。在上述条件下，破乳效果良好，出水清澈透明，ＣＯＤ总去除率可达到９６％—９７％。
An O/W emulsion wastewater has been treated by dosing PFS as an emulsion breaker and then by an electrolysis process for emulsion breaking.The conditions of emulsion breaking are as follows: 1500mg/L of PFS dosage under pH7 for the former process;iron anode,0. 86A/dm2 of current density,25mm of distance between electrodes and 3h of electrolysis time for the latter process.Under the above-conditions,the effect of emulsion breaking is good, the effluent is clear and the total COD removal rate can come up to 96% 97%.
出处
《化工环保》
CAS
CSCD
北大核心
1996年第1期26-30,共5页
Environmental Protection of Chemical Industry
关键词
破乳
破乳剂
乳化液处理
废水处理
聚合硫酸铁
s:emulsion breaking, emulsion breaker,emulsion wastewater treatment.
