Based on Reynolds-averaged Navier-Stokes approach,a laminar-turbulence transition model is proposed in this study that takes into account the effects of different instability modes associated with the variations in Ma...Based on Reynolds-averaged Navier-Stokes approach,a laminar-turbulence transition model is proposed in this study that takes into account the effects of different instability modes associated with the variations in Mach numbers of compressible boundary layer flows.The model is based on k-ω-γ three-equation eddy-viscosity concept with k representing the fluctuating kinetic energy,ωthe specific dissipation rate and the intermittency factorγ.The particular features of the model are that:1)k includes the non-turbulent,as well as turbulent fluctuations;2)a transport equation for the intermittency factorγis proposed here with a source term set to trigger the transition onset;3)through the introduction of a new length scale normal to wall,the present model employs the local variables only avoiding the use of the integral parameters,like the boundary layer thicknessδ,which are often cost-ineffective with the modern CFD(Computational Fluid Dynamics)methods;4)in the fully turbulent region,the model retreats to the well-known k-ωSST(Shear Stress Transport)model.This model is validated with a number of available experiments on boundary layer transitions including the incompressible,supersonic and hypersonic flows past flat plates,straight/flared cones at zero incidences,etc.It is demonstrated that the present model can be successfully applied to the engineering calculations of a variety of aerodynamic flow transition.展开更多
This paper describes a simplified transition model based on the recently developed correlation-based γ - Reot transition model. The transport equation of transition momentum thick- ness Reynolds number is eliminated ...This paper describes a simplified transition model based on the recently developed correlation-based γ - Reot transition model. The transport equation of transition momentum thick- ness Reynolds number is eliminated for simplicity, and new transition length function and critical Reynolds number correlation are proposed. The new model is implemented into an in-house com- putational fluid dynamics （CFD） code and validated for low and high-speed flow cases, including the zero pressure flat plate, airfoils, hypersonic flat plate and double wedge. Comparisons between the simulation results and experimental data show that the boundary-layer transition phenomena can be reasonably illustrated by the new model, which gives rise to significant improvements over the fully laminar and fully turbulent results. Moreover, the new model has comparable features of accuracy and applicability when compared with the original 3＇ - Reot model. In the meantime, the newly proposed model takes only one transport equation of intermittency factor and requires fewer correlations, which simplifies the original model greatly. Further studies, especially on separation- induced transition flows, are required for the improvement of the new model.展开更多
为了验证放大因子输运方程与Spalart-Allmaras(S-A)湍流模型耦合对转捩现象的模拟精度,选取Schubauer and Klebanoff(S-K)平板、S809低速翼型、30p30n多段翼型以及复杂的三维HiLiftPW-1构型进行自由转捩计算,并将计算结果与实验进行比...为了验证放大因子输运方程与Spalart-Allmaras(S-A)湍流模型耦合对转捩现象的模拟精度,选取Schubauer and Klebanoff(S-K)平板、S809低速翼型、30p30n多段翼型以及复杂的三维HiLiftPW-1构型进行自由转捩计算,并将计算结果与实验进行比较分析,其中针对S809算例,还与Langtry-Menter(L-M)转捩模型进行了比较.算例结果表明:放大因子输运方程与S-A湍流模型的耦合能够较好的捕捉转捩位置以及转捩发展过程,对分离泡诱导的转捩的模拟相比L-M转捩模型更精确,转捩位置的捕捉精度提升了10%;对比实验,多段翼转捩位置的捕捉误差最大为6.5%;针对三维高升力增升构型,以实验作为参考,全湍流计算与考虑边界层转捩的对比显示考虑边界层转捩能够更加精确的模拟气动力系数,升力和表面摩擦阻力系数的模拟精度精度提升1%.展开更多
In gas turbine engines, laminar-turbulent transition occurs. However, generally, the turbulence models to describe such transition results in too early and too short transition. Combining a turbulence model with a des...In gas turbine engines, laminar-turbulent transition occurs. However, generally, the turbulence models to describe such transition results in too early and too short transition. Combining a turbulence model with a description of intermittency, i.e. the fraction of time the flow is turbulent during the transition phase, can improve it. By letting grow the intermittency from zero to unity, start and evolution of transition can be imposed. In this paper, a method where a dynamic equation of intermittency combining with a two-equation k-ωturbulence model is described. This intermittency factor is a premultiplicator of the turbulent viscosity computed by the turbulence model. Following a suggestion by Menter et al.[1], the start of transition is computed based on local variables.展开更多
基金Supported by the National Natural Science Foundation of China(Grant Nos.10232020 and 90505005)
文摘Based on Reynolds-averaged Navier-Stokes approach,a laminar-turbulence transition model is proposed in this study that takes into account the effects of different instability modes associated with the variations in Mach numbers of compressible boundary layer flows.The model is based on k-ω-γ three-equation eddy-viscosity concept with k representing the fluctuating kinetic energy,ωthe specific dissipation rate and the intermittency factorγ.The particular features of the model are that:1)k includes the non-turbulent,as well as turbulent fluctuations;2)a transport equation for the intermittency factorγis proposed here with a source term set to trigger the transition onset;3)through the introduction of a new length scale normal to wall,the present model employs the local variables only avoiding the use of the integral parameters,like the boundary layer thicknessδ,which are often cost-ineffective with the modern CFD(Computational Fluid Dynamics)methods;4)in the fully turbulent region,the model retreats to the well-known k-ωSST(Shear Stress Transport)model.This model is validated with a number of available experiments on boundary layer transitions including the incompressible,supersonic and hypersonic flows past flat plates,straight/flared cones at zero incidences,etc.It is demonstrated that the present model can be successfully applied to the engineering calculations of a variety of aerodynamic flow transition.
基金supported by the State Key Development Program for Basic Research of China(No.2014CB340201)
文摘This paper describes a simplified transition model based on the recently developed correlation-based γ - Reot transition model. The transport equation of transition momentum thick- ness Reynolds number is eliminated for simplicity, and new transition length function and critical Reynolds number correlation are proposed. The new model is implemented into an in-house com- putational fluid dynamics （CFD） code and validated for low and high-speed flow cases, including the zero pressure flat plate, airfoils, hypersonic flat plate and double wedge. Comparisons between the simulation results and experimental data show that the boundary-layer transition phenomena can be reasonably illustrated by the new model, which gives rise to significant improvements over the fully laminar and fully turbulent results. Moreover, the new model has comparable features of accuracy and applicability when compared with the original 3＇ - Reot model. In the meantime, the newly proposed model takes only one transport equation of intermittency factor and requires fewer correlations, which simplifies the original model greatly. Further studies, especially on separation- induced transition flows, are required for the improvement of the new model.
文摘为了验证放大因子输运方程与Spalart-Allmaras(S-A)湍流模型耦合对转捩现象的模拟精度,选取Schubauer and Klebanoff(S-K)平板、S809低速翼型、30p30n多段翼型以及复杂的三维HiLiftPW-1构型进行自由转捩计算,并将计算结果与实验进行比较分析,其中针对S809算例,还与Langtry-Menter(L-M)转捩模型进行了比较.算例结果表明:放大因子输运方程与S-A湍流模型的耦合能够较好的捕捉转捩位置以及转捩发展过程,对分离泡诱导的转捩的模拟相比L-M转捩模型更精确,转捩位置的捕捉精度提升了10%;对比实验,多段翼转捩位置的捕捉误差最大为6.5%;针对三维高升力增升构型,以实验作为参考,全湍流计算与考虑边界层转捩的对比显示考虑边界层转捩能够更加精确的模拟气动力系数,升力和表面摩擦阻力系数的模拟精度精度提升1%.
文摘In gas turbine engines, laminar-turbulent transition occurs. However, generally, the turbulence models to describe such transition results in too early and too short transition. Combining a turbulence model with a description of intermittency, i.e. the fraction of time the flow is turbulent during the transition phase, can improve it. By letting grow the intermittency from zero to unity, start and evolution of transition can be imposed. In this paper, a method where a dynamic equation of intermittency combining with a two-equation k-ωturbulence model is described. This intermittency factor is a premultiplicator of the turbulent viscosity computed by the turbulence model. Following a suggestion by Menter et al.[1], the start of transition is computed based on local variables.
