无刷直流电机(brushless DC motor,BLDCM)换相时刻关断相电流的续流造成电机端电压的畸变。当采用无位置传感器反电动势过零检测法时,端电压波形畸变会使位置检测信号相位超前,偏离最佳换相时刻,重载条件下甚至会造成换相失败,制约了反...无刷直流电机(brushless DC motor,BLDCM)换相时刻关断相电流的续流造成电机端电压的畸变。当采用无位置传感器反电动势过零检测法时,端电压波形畸变会使位置检测信号相位超前,偏离最佳换相时刻,重载条件下甚至会造成换相失败,制约了反电动势检测法的电机功率应用范围。因此,该文针对电流续流影响端电压的机理加以分析,建立了电流续流产生相位超前的数学模型,并给出了位置检测信号相位超前的补偿算法。仿真和实验结果表明,经过补偿后的位置检测接近最佳换相时刻,重载条件下仍可正常运行。展开更多
A new 300 MVA/1350 MJ motor generator （MG） will be built to feed all of the poloidal field power supplies （PFPS） and auxiliary heating power supplies of the HL-2M tokamak. The MG has a vertical-shaft salient pole ...A new 300 MVA/1350 MJ motor generator （MG） will be built to feed all of the poloidal field power supplies （PFPS） and auxiliary heating power supplies of the HL-2M tokamak. The MG has a vertical-shaft salient pole 6-phase synchronous generator and a coaxial 8500 kW induction motor. The Ohmic heating power supply （OHPS） consisting of 4-quadrant DC pulsed convertor is the one with the highest parameters among the PFPS. Therefore, the match between the generator and the OHPS is very important. The matching study with Matlab/Simulink is described in this paper. The simulation results show that the subtransient reactance of the generator is closely related to the inversion operation of the OHPS. By setting various subtransient reactance in the simulation generator model and considering the cost reduction, the optimized parameters are obtained as xd＂ = 0.405 p.u. at 100 Hz for the generator. The models built in the simulation can be used as an important tool for studying the dynamic characteristics and the control strategy of other HL-2M PFPSes.展开更多
Practically,the load currents in three phases are asymmetric in the power system.It means that the impedances are different in all three phases.If the consumer’s transformer neutral cut off and/or was disconnected fr...Practically,the load currents in three phases are asymmetric in the power system.It means that the impedances are different in all three phases.If the consumer’s transformer neutral cut off and/or was disconnected from the neutral of power supply source,then there will be some trouble and failure occurred.The current in the neutral wire drops down to zero when the neutral wire is cut off and the phase currents of all three-phase equal to each other since there was no return wire.The currents are equal but the voltages at the phase consumers are different.Especially for residential single-phase consumers,the voltage at the consumers of the phase varies differently for three phase systems when the neutral wire was disconnected at consumer side and even the voltage at the consumers one or two of those three phases becomes over nominal voltage or reaches nearly line voltage.In this case,the electronic appliances in that phase will be fed by high voltage than the rated value and they can be broken down.In the power system of UB(Ulaanbaatar)city,there are some occasional such kind of failures every year.Obviously,many electronic appliances were broken down due to high voltage and the electricity utility companies respond for service charge of damaged parts.展开更多
为了增加单位增益频率与压摆率,并能够工作在低电源电压下,同时降低偏置电流,提出了一种改进的基于0.18μm CMOS工艺的AB类放大器,其采用多级放大器结构,第一级为具有电流镜负载的NMOS差分对,第二反相级由共源放大器实现,第三极为AB类...为了增加单位增益频率与压摆率,并能够工作在低电源电压下,同时降低偏置电流,提出了一种改进的基于0.18μm CMOS工艺的AB类放大器,其采用多级放大器结构,第一级为具有电流镜负载的NMOS差分对,第二反相级由共源放大器实现,第三极为AB类放大器,其能够在±500 m V电源下工作.电路仿真结果显示该放大器相位裕度为87°;总补偿电容为5 p F,与传统放大器相比减少了50%;单位增益频率为21.17 MHz,比传统放大器增大约10倍;压摆率为7.5和8.57 V/μs,与传统电路相比,分别增加了2.8倍和2.6倍.此外,与其他文献相比,该放大器具有较大的单位增益带宽和压摆率以及较小的功耗.展开更多
文摘无刷直流电机(brushless DC motor,BLDCM)换相时刻关断相电流的续流造成电机端电压的畸变。当采用无位置传感器反电动势过零检测法时,端电压波形畸变会使位置检测信号相位超前,偏离最佳换相时刻,重载条件下甚至会造成换相失败,制约了反电动势检测法的电机功率应用范围。因此,该文针对电流续流影响端电压的机理加以分析,建立了电流续流产生相位超前的数学模型,并给出了位置检测信号相位超前的补偿算法。仿真和实验结果表明,经过补偿后的位置检测接近最佳换相时刻,重载条件下仍可正常运行。
文摘A new 300 MVA/1350 MJ motor generator （MG） will be built to feed all of the poloidal field power supplies （PFPS） and auxiliary heating power supplies of the HL-2M tokamak. The MG has a vertical-shaft salient pole 6-phase synchronous generator and a coaxial 8500 kW induction motor. The Ohmic heating power supply （OHPS） consisting of 4-quadrant DC pulsed convertor is the one with the highest parameters among the PFPS. Therefore, the match between the generator and the OHPS is very important. The matching study with Matlab/Simulink is described in this paper. The simulation results show that the subtransient reactance of the generator is closely related to the inversion operation of the OHPS. By setting various subtransient reactance in the simulation generator model and considering the cost reduction, the optimized parameters are obtained as xd＂ = 0.405 p.u. at 100 Hz for the generator. The models built in the simulation can be used as an important tool for studying the dynamic characteristics and the control strategy of other HL-2M PFPSes.
文摘Practically,the load currents in three phases are asymmetric in the power system.It means that the impedances are different in all three phases.If the consumer’s transformer neutral cut off and/or was disconnected from the neutral of power supply source,then there will be some trouble and failure occurred.The current in the neutral wire drops down to zero when the neutral wire is cut off and the phase currents of all three-phase equal to each other since there was no return wire.The currents are equal but the voltages at the phase consumers are different.Especially for residential single-phase consumers,the voltage at the consumers of the phase varies differently for three phase systems when the neutral wire was disconnected at consumer side and even the voltage at the consumers one or two of those three phases becomes over nominal voltage or reaches nearly line voltage.In this case,the electronic appliances in that phase will be fed by high voltage than the rated value and they can be broken down.In the power system of UB(Ulaanbaatar)city,there are some occasional such kind of failures every year.Obviously,many electronic appliances were broken down due to high voltage and the electricity utility companies respond for service charge of damaged parts.
文摘为了增加单位增益频率与压摆率,并能够工作在低电源电压下,同时降低偏置电流,提出了一种改进的基于0.18μm CMOS工艺的AB类放大器,其采用多级放大器结构,第一级为具有电流镜负载的NMOS差分对,第二反相级由共源放大器实现,第三极为AB类放大器,其能够在±500 m V电源下工作.电路仿真结果显示该放大器相位裕度为87°;总补偿电容为5 p F,与传统放大器相比减少了50%;单位增益频率为21.17 MHz,比传统放大器增大约10倍;压摆率为7.5和8.57 V/μs,与传统电路相比,分别增加了2.8倍和2.6倍.此外,与其他文献相比,该放大器具有较大的单位增益带宽和压摆率以及较小的功耗.
