Gadolinium gallium gamet （GGG） nanopowders doped with ytterbium ions （Yb：GGG） were synthesized with citric acid as a fuel via gel combustion method. The optimized conditions for preparing yb^3＋：Gd3Ga5O12 nanopo...Gadolinium gallium gamet （GGG） nanopowders doped with ytterbium ions （Yb：GGG） were synthesized with citric acid as a fuel via gel combustion method. The optimized conditions for preparing yb^3＋：Gd3Ga5O12 nanopowders were discussed. The heat behavior, structure and morphology of powders were analyzed with thermal analysis （TG-DTA）, X-ray diffraction （XRD）, infrared spectra OR） and transmission electron microscope （TEM）. TG-DTA analysis revealed that the weight loss of the precursor occured below 800 ℃ and its crystallization temperature was 830.6℃. XRD and IR analysis showed that the precursor converted directly into pure GGG at a relatively lower temperature （900 ℃） without any other intermediate phase. The lattice constant was 1.2377 calculated by extrapolation method. TEM results indicated that the spherical powders showed good dispersity and had a relatively narrow size distribution with average particle size of approximately 40-50 ran, which was favorable for good sinterability of Yb：GGG laser ceramic.展开更多
Er3+ and La3+ codoped Y2O3 nanocrystalline powders were synthesized by gel combustion method and characterized with thermal analysis, X-ray diffraction (XRD), transmission electron microscopy (TEM), high-resolution TE...Er3+ and La3+ codoped Y2O3 nanocrystalline powders were synthesized by gel combustion method and characterized with thermal analysis, X-ray diffraction (XRD), transmission electron microscopy (TEM), high-resolution TEM (HRTEM) techniques and fluorescence spectroscopy. After being calcined at 1200 oC, the (Y1–xLax)2O3:Er3+ powders were confirmed to be cubic Y2O3 phase with the crystalline grain size in the range of 20–40 nm. The Er3+ emission at 1.53μm from the4I13/2→4I15/2 transition was observed, which was found to be enhanced by introducing La3+ ions. Such enhancement could be attributed to the adjustment of Er3+ ions’ local environment by the codoping of La3+ ions, leading to the increased ground state absorption cross section of Er3+ ions.展开更多
Yellow-emitting YAG：Ce3＋ nanocrystalline phosphors were prepared by citrate sol-gel combustion method using citric acid as the fuel and chelating agent. The influence of mole ratio of citric acid to metallic ions （...Yellow-emitting YAG：Ce3＋ nanocrystalline phosphors were prepared by citrate sol-gel combustion method using citric acid as the fuel and chelating agent. The influence of mole ratio of citric acid to metallic ions （MRCM）, pH value of the solution, calcination temperature and Ce-doped concentration on the structures and properties of as-prepared powders were investigated in detail. Higher crystallinity and better luminescence performance powders were obtained at MRCM=2, pH=3 and the calcination temperature of 1200 ℃. The phosphors exhibited the charactefistc broadband visible luminescence of YAG：Ce. The optimum concentration of Ce3＋ was 1.0 tool.%, and the concentration quenching was derived from the reciprocity between electric dipole and electric quadrupole （d-q）. Especially, the pH value of the solution was a key factor to obtain a stable sol-gel system and then obtain pure and homogeneous rare earth ions doped YAG phosphors at a lower tem- perature. The Y3Al5O12：Ce0.03 phosphor with optimized synthesis-condition and composition had a similar luminescence intensity with the commercial phosphor YAG：Ce.展开更多
Nanocrystal SmBO3 powders were synthesized by nitrate-citrate sol-gel combustion method. The phase evolution, morphologies and absorbency of the synthesized powders were characterized by X-ray diffraction （XRD）, Fie...Nanocrystal SmBO3 powders were synthesized by nitrate-citrate sol-gel combustion method. The phase evolution, morphologies and absorbency of the synthesized powders were characterized by X-ray diffraction （XRD）, Field emission scanning electronic microscope （FESEM）, Fourier transform infrared spectroscopy （FFIR） and UV-3101PC spectrophotometer （UVPC）, respectively. XRD and FESEM results showed that pure SmBO3 phase was obtained at 750 ℃, with an average original particle size of about 100 nm. FTIR showed that there were apparently concentrated absorbent peaks between 500 and 1400 cm^-1. Moreover, the reflectivity of the powders apparently decreased at the wavelength between 1.05 and 1.15 μm. Therefore, SmBO3 might be a kind of absorbent material for infrared laser.展开更多
基金supported by the Foundation of Ordnance Science Institute (42001070403)
文摘Gadolinium gallium gamet （GGG） nanopowders doped with ytterbium ions （Yb：GGG） were synthesized with citric acid as a fuel via gel combustion method. The optimized conditions for preparing yb^3＋：Gd3Ga5O12 nanopowders were discussed. The heat behavior, structure and morphology of powders were analyzed with thermal analysis （TG-DTA）, X-ray diffraction （XRD）, infrared spectra OR） and transmission electron microscope （TEM）. TG-DTA analysis revealed that the weight loss of the precursor occured below 800 ℃ and its crystallization temperature was 830.6℃. XRD and IR analysis showed that the precursor converted directly into pure GGG at a relatively lower temperature （900 ℃） without any other intermediate phase. The lattice constant was 1.2377 calculated by extrapolation method. TEM results indicated that the spherical powders showed good dispersity and had a relatively narrow size distribution with average particle size of approximately 40-50 ran, which was favorable for good sinterability of Yb：GGG laser ceramic.
基金supported by the Natural Science Foundation of Zhejiang Province(LQ13F050003)
文摘Er3+ and La3+ codoped Y2O3 nanocrystalline powders were synthesized by gel combustion method and characterized with thermal analysis, X-ray diffraction (XRD), transmission electron microscopy (TEM), high-resolution TEM (HRTEM) techniques and fluorescence spectroscopy. After being calcined at 1200 oC, the (Y1–xLax)2O3:Er3+ powders were confirmed to be cubic Y2O3 phase with the crystalline grain size in the range of 20–40 nm. The Er3+ emission at 1.53μm from the4I13/2→4I15/2 transition was observed, which was found to be enhanced by introducing La3+ ions. Such enhancement could be attributed to the adjustment of Er3+ ions’ local environment by the codoping of La3+ ions, leading to the increased ground state absorption cross section of Er3+ ions.
基金Project supported by the Priority Academic Program Development of Jiangsu Higher Education Institutions (PAPD)Jiangsu Provincial Natural Sciences Fund (BK2007724)
文摘Yellow-emitting YAG：Ce3＋ nanocrystalline phosphors were prepared by citrate sol-gel combustion method using citric acid as the fuel and chelating agent. The influence of mole ratio of citric acid to metallic ions （MRCM）, pH value of the solution, calcination temperature and Ce-doped concentration on the structures and properties of as-prepared powders were investigated in detail. Higher crystallinity and better luminescence performance powders were obtained at MRCM=2, pH=3 and the calcination temperature of 1200 ℃. The phosphors exhibited the charactefistc broadband visible luminescence of YAG：Ce. The optimum concentration of Ce3＋ was 1.0 tool.%, and the concentration quenching was derived from the reciprocity between electric dipole and electric quadrupole （d-q）. Especially, the pH value of the solution was a key factor to obtain a stable sol-gel system and then obtain pure and homogeneous rare earth ions doped YAG phosphors at a lower tem- perature. The Y3Al5O12：Ce0.03 phosphor with optimized synthesis-condition and composition had a similar luminescence intensity with the commercial phosphor YAG：Ce.
基金supported by the 973 Research Project of China (6134502)
文摘Nanocrystal SmBO3 powders were synthesized by nitrate-citrate sol-gel combustion method. The phase evolution, morphologies and absorbency of the synthesized powders were characterized by X-ray diffraction （XRD）, Field emission scanning electronic microscope （FESEM）, Fourier transform infrared spectroscopy （FFIR） and UV-3101PC spectrophotometer （UVPC）, respectively. XRD and FESEM results showed that pure SmBO3 phase was obtained at 750 ℃, with an average original particle size of about 100 nm. FTIR showed that there were apparently concentrated absorbent peaks between 500 and 1400 cm^-1. Moreover, the reflectivity of the powders apparently decreased at the wavelength between 1.05 and 1.15 μm. Therefore, SmBO3 might be a kind of absorbent material for infrared laser.
