期刊文献+
共找到6篇文章
< 1 >
每页显示 20 50 100
利用SSA热分级技术研究共聚甲醛序列结构 被引量:4
1
作者 杨大志 李建华 +1 位作者 李化毅 李倩 《石油化工》 CAS CSCD 北大核心 2019年第2期124-128,共5页
连续自成核热退火技术(SSA)可以根据聚合物结晶序列长度进行选择性结晶热分级,选取四种结构组成相似但热稳定性不同的共聚甲醛(CPOM)试样,通过DSC,TG,~1H NMR、HCHO含量(GM值)以及SSA热分析技术研究了CPOM的热稳定性与其结晶序列分布之... 连续自成核热退火技术(SSA)可以根据聚合物结晶序列长度进行选择性结晶热分级,选取四种结构组成相似但热稳定性不同的共聚甲醛(CPOM)试样,通过DSC,TG,~1H NMR、HCHO含量(GM值)以及SSA热分析技术研究了CPOM的热稳定性与其结晶序列分布之间的关系。表征结果显示,结晶性能参数主要受共聚单体含量影响;结晶链段分布窄,共聚单体分布更均匀,CPOM的GM值更小,热加工稳定性更好;含有不稳定端基,以及共聚单体分布不均匀会导致GM值偏高;SSA热分级结果与GM值之间有较好的对应关系。 展开更多
关键词 共聚甲醛 共聚单体分布 连续自成核热退火技术 甲醛含量
下载PDF
乙丙橡胶共聚物的^(13)C—NMR研究 被引量:2
2
作者 汪道明 赵发祥 +1 位作者 武一鸣 张志平 《波谱学杂志》 CAS CSCD 1991年第4期469-477,共9页
用溶剂CCl_4,在室温(22℃)条件下,对三种乙丙橡胶共聚物进行^(13)C-NMR测定,得到分辨率较高的图谱,标识了各种类型C原子,确定了共聚单体组成和序列分布。结果表明,样品A、B具有嵌段丙烯和嵌段乙烯序列结构可能性较大,样品C具有交替丙烯... 用溶剂CCl_4,在室温(22℃)条件下,对三种乙丙橡胶共聚物进行^(13)C-NMR测定,得到分辨率较高的图谱,标识了各种类型C原子,确定了共聚单体组成和序列分布。结果表明,样品A、B具有嵌段丙烯和嵌段乙烯序列结构可能性较大,样品C具有交替丙烯-乙烯-丙烯序列的倾向较大。用两种统计模型对三个样品的三元组分布进行处理来推测聚合反应机理。 展开更多
关键词 乙丙橡胶 共聚物 NMR 序列分布
下载PDF
CRYSTALLIZATION KINETICS OF ETHYLENE-PROPYLENE COPOLYMERS PREPARED BY LIVING COORDINATION POLYMERIZATION
3
作者 徐君庭 《Chinese Journal of Polymer Science》 SCIE CAS CSCD 2008年第5期589-595,共7页
In this paper,crystallization kinetics of a series of ethylene-propylene copolymers prepared by living polymerization coordination catalyzed by a fluorinated bis(phenoxyimine)Ti catalyst(FI-EP copolymers)was studied,a... In this paper,crystallization kinetics of a series of ethylene-propylene copolymers prepared by living polymerization coordination catalyzed by a fluorinated bis(phenoxyimine)Ti catalyst(FI-EP copolymers)was studied,and was compared with that of ethylene-propylene copolymers prepared by a conventional Ziegler-Natta catalyst(ZN-EP copolymers).It is found that,the Avrami exponent and the crystallization rate constant of the FI-EP and ZN-EP copolymer show similar dependence on crystallization temperature,but t... 展开更多
关键词 comonomer distribution CRYSTALLIZATION Ethylene-propylene copolymer.
下载PDF
Ethylene Copolymerization with Linear and End-Cyclized Olefins via a Metallocene Catalyst:Polymerization Behavior and Thermal Properties of Copolymers
4
作者 Changjiang Wu Minqiao Ren +5 位作者 Liping Hou Shuzhang Qu Xinwei Li Cui Zheng Jian Chen Wei Wang 《Engineering》 SCIE EI CAS CSCD 2023年第11期93-99,共7页
Olefin solution polymerization can be used to obtain high-performance polyolefin materials that cannot be obtained via other polymerization processes.Polyolefin elastomers(POE)are a typical example.Due to cost,only a ... Olefin solution polymerization can be used to obtain high-performance polyolefin materials that cannot be obtained via other polymerization processes.Polyolefin elastomers(POE)are a typical example.Due to cost,only a few linear a-olefins(e.g.,1-butene,1-hexene,and 1-octene)are used as comonomers in solution polymerization in industry.However,a-olefin comonomers with other structures may have different effects on polymerization in comparison with common linear ones.Moreover,the properties of the corresponding materials may differ significantly.In this work,copolymers of ethylene with linear and endcyclized a-olefins are synthesized using a metallocene catalyst.The copolymerization of ethylene with linear a-olefins results in a higher turn-over frequency(TOF)and lower incorporation than copolymerization with end-cyclized a-olefins,which may indicate that end-cyclized a-olefins have a higher coordination probability and lower insertion rate.In this reaction,the comonomer is distributed randomly in the polymer chain and efficiently destroys crystallization.End-cyclized a-olefins exhibit a much stronger crystallization destructive capacity(CDC)in the copolymer than linear a-olefins,possibly because linear a-olefins act mainly in the radial direction of the main chain of the polymer,while end-cyclized a-olefins act mainly in the axial direction of the main chain. 展开更多
关键词 Metallocene catalyst Ethylene copolymerization comonomer distribution Crystallization destructive capacity
下载PDF
COMONOMER SEQUENCE DISTRIBUTION IN METALLOCENE-BASED ETHYLENE/1-BUTENE (S-34) AND ETHYLENE/1-HEXENE (S-43) COPOLYMERS
5
作者 Xiu-wen Han Xiu-mei Liu +4 位作者 Jin-kai Zhao Xin-he Bao Wei Chen Yi Deng Zhen-hua Jing Dalian Institute of Chemical Physics, Chinese Academy of Sciences, Dalian 116023, China Research Institute of Petroleum Processing, Beijing 100083, China 《Chinese Journal of Polymer Science》 SCIE CAS CSCD 1999年第2期141-144,共4页
Metallocene based polyethylenes were prepared by SMOPEC's 'metallocene adduct' technology in a gas phase fluidized bed model reactor. The C-13-NMR spectra of ethylene/1-butene (S-34) and ethylene/1-hexene(... Metallocene based polyethylenes were prepared by SMOPEC's 'metallocene adduct' technology in a gas phase fluidized bed model reactor. The C-13-NMR spectra of ethylene/1-butene (S-34) and ethylene/1-hexene(S-43) copolymers were studied in a manner analogous to that established by Hsieh and Cheng. The comonomer sequence distributions of copolymer samples were obtained. The results show that these metallocene based copolymers contain a small amount of butene and hexene, and the EE and EEE sequences are dominant. 展开更多
关键词 METALLOCENE comonomer sequence distribution C-13-NMR
下载PDF
PE100级管材专用树脂的结构和性能 被引量:1
6
作者 关莉 胡斌 +2 位作者 朱军 席军 缪江 《合成树脂及塑料》 CAS 北大核心 2017年第1期70-72,80,共4页
对两种采用不同工艺生产的PE100级管材专用树脂(分别记作树脂A和树脂B)进行了结构剖析和管材加工性能评价。结果表明:与树脂A相比,树脂B的共聚单体含量少,重均分子量大,相对分子质量分布略窄,结晶度高,零剪切黏度高,熔体强度大;相同加... 对两种采用不同工艺生产的PE100级管材专用树脂(分别记作树脂A和树脂B)进行了结构剖析和管材加工性能评价。结果表明:与树脂A相比,树脂B的共聚单体含量少,重均分子量大,相对分子质量分布略窄,结晶度高,零剪切黏度高,熔体强度大;相同加工温度条件下,树脂A的加工流动性好,树脂B的抗熔垂性好;两种树脂所制管材的静液压强度、耐慢速裂纹增长性能与耐快速裂纹扩展性能均满足国家标准要求。 展开更多
关键词 管材专用树脂 共聚单体 流变性能 相对分子质量及其分布
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部