Acetone Planar Lase-Induced Fluorescence(PLIF)and OH-PLIF were employed to capture the fuel distribution and OH distribution downstream for the supersonic combustor based on the alternating-wedge strut.The combustion ...Acetone Planar Lase-Induced Fluorescence(PLIF)and OH-PLIF were employed to capture the fuel distribution and OH distribution downstream for the supersonic combustor based on the alternating-wedge strut.The combustion establishment process and combustion mode in the combustor under different fuel injection methods and different equivalence ratios were analyzed.Combined with the kerosene-PLIF and OH-PLIF results in the cavity combustor,a comparative analysis was conducted to understand the combustion characteristics and combustion modes between the alternating-wedge strut-based combustor and the cavity-based combustor.The results show that the combustor is in weak combustion mode in the case of low equivalence ratio,and the combustor is in intensive combustion mode in the case of high equivalence ratio.The lower limit of the equivalence ratio of the combustor to maintain the intensive combustion mode varies based on different fuel injection methods.The OH distribution under reacting condition has a strong correlation with the fuel distribution under non-reacting condition.The OH fluorescence signal near the injector is weaker when the fuel distribution is more concentrated.The injector position located at the base of the strut rear has better mixing performance,enabling the combustor to be in intensive combustion mode at a lower equivalence ratio.The combustion reaction in the alternating-wedge strut-based combustor is not necessarily dominated by mass transfer due to the mixing enhancement and premixed zone downstream of strut,while the combustion reaction process in the cavity-based combustor is mainly influenced by mass transfer.展开更多
The effects of alternating current poling(ACP)at 80℃on electrical properties of[001]-oriented 0.72 Pb(Mg_(1/3)Nb_(2/3))O_(3)-0.28PbTiO_(3)(PMN-28PT)single crystals(SCs)have been investigated.The square-wave ACP SCs p...The effects of alternating current poling(ACP)at 80℃on electrical properties of[001]-oriented 0.72 Pb(Mg_(1/3)Nb_(2/3))O_(3)-0.28PbTiO_(3)(PMN-28PT)single crystals(SCs)have been investigated.The square-wave ACP SCs poled at high voltage(HV,5 kV_(rms)/cm)occasionally showed large fluctuations and low opposite values of piezoelectric coefficient(d_(33)=±1370 pC/N)in one plate.This revealed spuriousmode vibrations(SMV)of impedance spectrum.However,after depolarizing and repolarizing the sample with a sine-wave ACP at low voltage(LV,3.5 kV_(rms)/cm),the d_(33) enhanced to be 1720 pC/N(+26%)and did not exhibit large fluctuation or opposite values in one plate any more.The impedance spectrum became clean and the abnormal SMV disappeared.We proposed four possible mechanisms of the SMV,and speculate that the main cause maybe by macro-scale sub-domain structure and/or phase change in the main domain structure and/or phase in the SC plate due to the specific poling conditions not eternal mechanical damage of PMN-PT SCs.This study will be useful to realize a high d_(33) and improve other properties of PMN-PT ACP SC ultrasonic transducers without any SMV for high-frequency medical imaging equipment.展开更多
In order to achieve the target of reducing oil consumption to zero for pulverized coal(PC)boiler in power plant,the paper developed a novel coal pulverized ignition approach,called as Alternating-Current plasma(AC pla...In order to achieve the target of reducing oil consumption to zero for pulverized coal(PC)boiler in power plant,the paper developed a novel coal pulverized ignition approach,called as Alternating-Current plasma(AC plasma)ignition,with the advantages of excellent PC combustion behavior and longer electrode life-span.The scientific principle of how to generate the AC plasma arc was elaborated in detail.First,the experiments on life-span of electrodes inside AC plasma generator had been conducted,finding a workable way to extend its life-span beyond 530 hours.Second,a new AC plasma burner specifically designed for lean coal according to the principle of PC staged combustion had been illustrated with diagrams and then used to ignite the PC-air stream under four kinds of conditions with a varying AC plasma power from 150 kW to 300 kW,focusing on analyses of the influence of AC plasma power on combustion behaver,such as combustion temperature,carbon burnout rate as well as PC combustion regime.The following results showed that in the case of the power of the AC plasma was P=300 kW,a satisfied PC combustion process could achieved,with the average PC combustion temperature of about 940°C,combustion flame length of 6.3 m,and the total carbon burnout rate of up to 52.2%.In addition,about 80%of the nozzle outlet section was filled with bright flame,while 81%of the PC was in zone of the cylindrical flame regime.The PC combustion modes were changed repeatedly during the process of combustion,which went from homogeneous combustion mode at initial ignition stage to combined combustion mode and heterogeneous combustion mode at middle stage,finally to combined combustion mode at later stage.The research conclusion in this paper has proved that the AC plasma ignition approach is feasible and effective to ignite low-rank coal without the present of fuel oil.展开更多
文摘Acetone Planar Lase-Induced Fluorescence(PLIF)and OH-PLIF were employed to capture the fuel distribution and OH distribution downstream for the supersonic combustor based on the alternating-wedge strut.The combustion establishment process and combustion mode in the combustor under different fuel injection methods and different equivalence ratios were analyzed.Combined with the kerosene-PLIF and OH-PLIF results in the cavity combustor,a comparative analysis was conducted to understand the combustion characteristics and combustion modes between the alternating-wedge strut-based combustor and the cavity-based combustor.The results show that the combustor is in weak combustion mode in the case of low equivalence ratio,and the combustor is in intensive combustion mode in the case of high equivalence ratio.The lower limit of the equivalence ratio of the combustor to maintain the intensive combustion mode varies based on different fuel injection methods.The OH distribution under reacting condition has a strong correlation with the fuel distribution under non-reacting condition.The OH fluorescence signal near the injector is weaker when the fuel distribution is more concentrated.The injector position located at the base of the strut rear has better mixing performance,enabling the combustor to be in intensive combustion mode at a lower equivalence ratio.The combustion reaction in the alternating-wedge strut-based combustor is not necessarily dominated by mass transfer due to the mixing enhancement and premixed zone downstream of strut,while the combustion reaction process in the cavity-based combustor is mainly influenced by mass transfer.
文摘The effects of alternating current poling(ACP)at 80℃on electrical properties of[001]-oriented 0.72 Pb(Mg_(1/3)Nb_(2/3))O_(3)-0.28PbTiO_(3)(PMN-28PT)single crystals(SCs)have been investigated.The square-wave ACP SCs poled at high voltage(HV,5 kV_(rms)/cm)occasionally showed large fluctuations and low opposite values of piezoelectric coefficient(d_(33)=±1370 pC/N)in one plate.This revealed spuriousmode vibrations(SMV)of impedance spectrum.However,after depolarizing and repolarizing the sample with a sine-wave ACP at low voltage(LV,3.5 kV_(rms)/cm),the d_(33) enhanced to be 1720 pC/N(+26%)and did not exhibit large fluctuation or opposite values in one plate any more.The impedance spectrum became clean and the abnormal SMV disappeared.We proposed four possible mechanisms of the SMV,and speculate that the main cause maybe by macro-scale sub-domain structure and/or phase change in the main domain structure and/or phase in the SC plate due to the specific poling conditions not eternal mechanical damage of PMN-PT SCs.This study will be useful to realize a high d_(33) and improve other properties of PMN-PT ACP SC ultrasonic transducers without any SMV for high-frequency medical imaging equipment.
基金supported by the national natural science foundation of china(Contract No.51806132)doctor start-up capital of Shanxi University(No.20174462)。
文摘In order to achieve the target of reducing oil consumption to zero for pulverized coal(PC)boiler in power plant,the paper developed a novel coal pulverized ignition approach,called as Alternating-Current plasma(AC plasma)ignition,with the advantages of excellent PC combustion behavior and longer electrode life-span.The scientific principle of how to generate the AC plasma arc was elaborated in detail.First,the experiments on life-span of electrodes inside AC plasma generator had been conducted,finding a workable way to extend its life-span beyond 530 hours.Second,a new AC plasma burner specifically designed for lean coal according to the principle of PC staged combustion had been illustrated with diagrams and then used to ignite the PC-air stream under four kinds of conditions with a varying AC plasma power from 150 kW to 300 kW,focusing on analyses of the influence of AC plasma power on combustion behaver,such as combustion temperature,carbon burnout rate as well as PC combustion regime.The following results showed that in the case of the power of the AC plasma was P=300 kW,a satisfied PC combustion process could achieved,with the average PC combustion temperature of about 940°C,combustion flame length of 6.3 m,and the total carbon burnout rate of up to 52.2%.In addition,about 80%of the nozzle outlet section was filled with bright flame,while 81%of the PC was in zone of the cylindrical flame regime.The PC combustion modes were changed repeatedly during the process of combustion,which went from homogeneous combustion mode at initial ignition stage to combined combustion mode and heterogeneous combustion mode at middle stage,finally to combined combustion mode at later stage.The research conclusion in this paper has proved that the AC plasma ignition approach is feasible and effective to ignite low-rank coal without the present of fuel oil.
