A new recovery technology is developed to recycle N,N-dimethyl formamide （DMF） in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6...A new recovery technology is developed to recycle N,N-dimethyl formamide （DMF） in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6- 688.3 mg·m^-3, it was necessary to make sure two phases contact adequately and strengthen the mass transfer by increasing contact area and enhancing the turbulence. Therefore, two-stage countercurrent absorption and two-stage fog removing system were introduced into the technology. The top section of the absorption column was filled with structured wire-ripple stainless steel packing BX500, while the lower section with sting-ripple packing CB250Y. Total height of packing material was 6 m. In addition, there were both two-stage fog removing layer and high efficiency liquid distributor at the column top. All the operating parameters, including temperature, pressure, flow rate and liquid position, could be controlled by computers without manual operation, making sure the outlet gas achieved the national emission standard that the DMF concentration should be below 40 mg·m^-3. The whole equipment could recover 237.6 t of DMF each year, with the profit up to CNY 521×10^3.展开更多
Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate （[C4mim][PF6]） and N, N-dimethylformamide （DMF） binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. ...Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate （[C4mim][PF6]） and N, N-dimethylformamide （DMF） binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. It is shown that the viscosities and densities decrease monotonously with temperature and the content of DMF. Various correlation methods including Arrhenius-like equation, Sedclon et al.＇s equation, Redlich-Kister equation with four parameters, and other empirical equations were applied to evaluate these experimental data. A model based on an equation of state Ior estimating the viscosity of mixtures containing ionic liquids were proposed by coupling with the excess Gibbs free energy model of viscosity, which can synchronously calculate the viscosity and the molar volume. The results show that the model gives a deviation of 8.29% for the viscosity, and a deviation of 1.05% for the molar volume when only one temperature-independent adjustable parameter is adopted. The correlation accuracy is further improved when two parameters or one temperature-dependent parameter is used.展开更多
基金the Science and Technology Fund of Zhejiang Province, China (2006C13072)
文摘A new recovery technology is developed to recycle N,N-dimethyl formamide （DMF） in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6- 688.3 mg·m^-3, it was necessary to make sure two phases contact adequately and strengthen the mass transfer by increasing contact area and enhancing the turbulence. Therefore, two-stage countercurrent absorption and two-stage fog removing system were introduced into the technology. The top section of the absorption column was filled with structured wire-ripple stainless steel packing BX500, while the lower section with sting-ripple packing CB250Y. Total height of packing material was 6 m. In addition, there were both two-stage fog removing layer and high efficiency liquid distributor at the column top. All the operating parameters, including temperature, pressure, flow rate and liquid position, could be controlled by computers without manual operation, making sure the outlet gas achieved the national emission standard that the DMF concentration should be below 40 mg·m^-3. The whole equipment could recover 237.6 t of DMF each year, with the profit up to CNY 521×10^3.
基金Supported by the National Natural Science Foundation of China （20476025, 20776040）, Shanghai Municipal Science and Technology Commission of China （05DJ14002） and Hubei Key Laboratory of Novel Chemical Reactor and Green Chemical Technology of China （XLHX2007002）.
文摘Viscosities and densities for 1-butyl-3-methylimidazolium hexafluorophosphate （[C4mim][PF6]） and N, N-dimethylformamide （DMF） binary mixtures have been measured at the temperature range from 293.15 K to 318.15 K. It is shown that the viscosities and densities decrease monotonously with temperature and the content of DMF. Various correlation methods including Arrhenius-like equation, Sedclon et al.＇s equation, Redlich-Kister equation with four parameters, and other empirical equations were applied to evaluate these experimental data. A model based on an equation of state Ior estimating the viscosity of mixtures containing ionic liquids were proposed by coupling with the excess Gibbs free energy model of viscosity, which can synchronously calculate the viscosity and the molar volume. The results show that the model gives a deviation of 8.29% for the viscosity, and a deviation of 1.05% for the molar volume when only one temperature-independent adjustable parameter is adopted. The correlation accuracy is further improved when two parameters or one temperature-dependent parameter is used.
