Low-voltage silicon （Si）-based light-emitting diode （LED） is designed based on the former research of LED in Si-based standard complementary metal oxide semiconductor （CMOS） technology. The low-voltage LED is de...Low-voltage silicon （Si）-based light-emitting diode （LED） is designed based on the former research of LED in Si-based standard complementary metal oxide semiconductor （CMOS） technology. The low-voltage LED is designed under the research of cross-finger structure LEDs and sophisticated structure enhanced LEDs for high efficiency and stable light source of monolithic chip integration. The device size of low-voltage LED is 45.85x38.4 （#m）, threshold voltage is 2.2 V in common condition, and temperature is 27 ~C. The external quantum efficiency is about 10-6 at stable operating state of 5 V and 177 mA.展开更多
A new approach to reduce the reverse current of Ge pin photodiodes on Si is presented, in which an i-Si layer is inserted between Ge and top Si layers to reduce the electric field in the Ge layer. Without post- growth...A new approach to reduce the reverse current of Ge pin photodiodes on Si is presented, in which an i-Si layer is inserted between Ge and top Si layers to reduce the electric field in the Ge layer. Without post- growth annealing, the reverse current density is reduced to -10 mA/cm^2 at -1 V, i.e., over one order of magnitude lower than that of the reference photodiode without i-Si layer. However, the responsivity of the photodiodes is not severely compromised. This lowered-reverse-current is explained by band-pinning at the i-Si/i-Ge interface. Barrier lowering mechanism induced by E-field is also discussed. The presented ＂non-thermal＂ approach to reduce reverse current should accelerate electronics-photonics convergence by using Oe on the Si complementary metal oxide semiconductor （CMOS） platform.展开更多
本文探索了一种能用于大规模 MOS 集成电路的栅氧化技术—补充后的两步 TCE法。笔者采用该法,在一般工厂的工艺条件下,制得了90%以上的 MOS 电容,击穿电场大于6MV/cm,可动电荷密度约为10^(10)cm^(-2),固定电荷密度约为10^(11)cm^(-2)的...本文探索了一种能用于大规模 MOS 集成电路的栅氧化技术—补充后的两步 TCE法。笔者采用该法,在一般工厂的工艺条件下,制得了90%以上的 MOS 电容,击穿电场大于6MV/cm,可动电荷密度约为10^(10)cm^(-2),固定电荷密度约为10^(11)cm^(-2)的优质超薄氧化层。展开更多
A current-mode MOS neuron circuit with 4-bit programmable weights is presented by using CMOS technology. The weights of the neurcn have high resolution and also can easily be digitally stored. The resolution can be ex...A current-mode MOS neuron circuit with 4-bit programmable weights is presented by using CMOS technology. The weights of the neurcn have high resolution and also can easily be digitally stored. The resolution can be extended into high levels such as 8-bit, etc. by the design methodology presented in this paper. The operational principle of the neuron is discussed. Circuit simulation has been made by use of SPICE II. The results give a good agreement for the design requirements.展开更多
This paper presents a novel approach to design robust Source Coupled Logic (SCL) for implementing ultra low power circuits. In this paper, we propose two different source coupled logic structures and analyze the perfo...This paper presents a novel approach to design robust Source Coupled Logic (SCL) for implementing ultra low power circuits. In this paper, we propose two different source coupled logic structures and analyze the performance of these structures with STSCL (Sub-threshold SCL). The first design under consideration is DTPMOS as load device which analyses the performance of Dynamic Threshold SCL (DTSCL) Logic with previous source coupled logic for ultra low power operation. DTSCL circuits exhibit a better power-delay Performance compared with the STSCL Logic. It can be seen that the proposed circuit provides 56% reduction in power delay product. The second design under consideration uses basic current mirror active load device to provide required voltage swing. Current mirror source coupled logic (CMSCL) can be used for high speed operation. The advantage of this design is that it provides 54% reduction in power delay product over conventional STSCL. The main drawback of this design is that it provides a higher power dissipation compared to other source coupled logic structures. The proposed circuit provides lower sensitivity to temperature and power supply variation, with a superior control over power dissipation. Measurements of test structures simulated in 0.18 μm CMOS technology shows that the proposed DTSCL logic concept can be utilized successfully for bias currents as low as 1 pA. Measurements show that existing standard cell libraries offer a good solution for ultra low power SCL circuits. Cadence Virtuoso schematic editor and Spectre Simulation tools have been used.展开更多
基金supported by the National Natural Science Foundation of China(Nos.61036002,60536030, 60776024,60877035,61076023,and 90820002)the National "863" Program of China(Nos.2007AA04Z329, 2007AA04Z254,2011CB933203,and 2011CB933102)
文摘Low-voltage silicon （Si）-based light-emitting diode （LED） is designed based on the former research of LED in Si-based standard complementary metal oxide semiconductor （CMOS） technology. The low-voltage LED is designed under the research of cross-finger structure LEDs and sophisticated structure enhanced LEDs for high efficiency and stable light source of monolithic chip integration. The device size of low-voltage LED is 45.85x38.4 （#m）, threshold voltage is 2.2 V in common condition, and temperature is 27 ~C. The external quantum efficiency is about 10-6 at stable operating state of 5 V and 177 mA.
基金supported by the Grant-in-Aid for Creative Scientific Research on Si CMOS Photonics in Japan.The meaeurecl devices were fabricated in the Takeda Sentanchi Facility of the University of Tokyo Japan.
文摘A new approach to reduce the reverse current of Ge pin photodiodes on Si is presented, in which an i-Si layer is inserted between Ge and top Si layers to reduce the electric field in the Ge layer. Without post- growth annealing, the reverse current density is reduced to -10 mA/cm^2 at -1 V, i.e., over one order of magnitude lower than that of the reference photodiode without i-Si layer. However, the responsivity of the photodiodes is not severely compromised. This lowered-reverse-current is explained by band-pinning at the i-Si/i-Ge interface. Barrier lowering mechanism induced by E-field is also discussed. The presented ＂non-thermal＂ approach to reduce reverse current should accelerate electronics-photonics convergence by using Oe on the Si complementary metal oxide semiconductor （CMOS） platform.
文摘A current-mode MOS neuron circuit with 4-bit programmable weights is presented by using CMOS technology. The weights of the neurcn have high resolution and also can easily be digitally stored. The resolution can be extended into high levels such as 8-bit, etc. by the design methodology presented in this paper. The operational principle of the neuron is discussed. Circuit simulation has been made by use of SPICE II. The results give a good agreement for the design requirements.
文摘This paper presents a novel approach to design robust Source Coupled Logic (SCL) for implementing ultra low power circuits. In this paper, we propose two different source coupled logic structures and analyze the performance of these structures with STSCL (Sub-threshold SCL). The first design under consideration is DTPMOS as load device which analyses the performance of Dynamic Threshold SCL (DTSCL) Logic with previous source coupled logic for ultra low power operation. DTSCL circuits exhibit a better power-delay Performance compared with the STSCL Logic. It can be seen that the proposed circuit provides 56% reduction in power delay product. The second design under consideration uses basic current mirror active load device to provide required voltage swing. Current mirror source coupled logic (CMSCL) can be used for high speed operation. The advantage of this design is that it provides 54% reduction in power delay product over conventional STSCL. The main drawback of this design is that it provides a higher power dissipation compared to other source coupled logic structures. The proposed circuit provides lower sensitivity to temperature and power supply variation, with a superior control over power dissipation. Measurements of test structures simulated in 0.18 μm CMOS technology shows that the proposed DTSCL logic concept can be utilized successfully for bias currents as low as 1 pA. Measurements show that existing standard cell libraries offer a good solution for ultra low power SCL circuits. Cadence Virtuoso schematic editor and Spectre Simulation tools have been used.
