One-dimensional Lu2O3:Eu3+ nanofibers were prepared by electrospinning followed by high-temperature calcinations.Thermogravimetric and differential thermal analysis,X-ray powder diffraction,Fourier transform infrared ...One-dimensional Lu2O3:Eu3+ nanofibers were prepared by electrospinning followed by high-temperature calcinations.Thermogravimetric and differential thermal analysis,X-ray powder diffraction,Fourier transform infrared spectroscopy,scanning electron microscopy,photoluminescent spectra and decay curves were used to characterize the samples.Results showed that samples began to crystallize at ～500 oC and crystallized completely around 1000 oC.The average diameter of nanofibers(1000 oC annealed) was about 55 nm and the particle size of Lu2O3:Eu3+ increased with increasing annealing temperature.Under ultraviolet excitation,nanofibers exhibited typical red emission of Eu3+ in Lu2O3.The effect of heat-treatment temperature on luminescent properties of nanofibers was also discussed.展开更多
In this paper,effect of two strategies on afterglow behavior of Lu_(2)O_(3):Eu single crystal scintillato r,Pr^(3+)codoping and solid solution with Sc_(2)O_(3),were studied systematically.Two groups of Lu_(2)O_(3):5 a...In this paper,effect of two strategies on afterglow behavior of Lu_(2)O_(3):Eu single crystal scintillato r,Pr^(3+)codoping and solid solution with Sc_(2)O_(3),were studied systematically.Two groups of Lu_(2)O_(3):5 at%Eu,x at%Pr(x=0,0.2,0.5,1,2 and 5)and(Lu1-yScy)_(2)O_(3):5 at%Eu(y=0,20 at%,50 at%and 70 at%)single crystals were grown by floating zone(FZ)method in air atmosphere.The structures of as-grown crystals were determined by X-ray diffraction(XRD).The scintillation,photoluminescence properties and carrier trap states were investigated through afterglow,X-ray excitation luminescence(XEL),transmittance,photoluminescence excitation(PLE)and photoluminescence(PL),PL decay and thermal stimulated luminescence(TSL)curves.It is found that with the increase of Pr^(3+)concentration,the afterglow level of the system decreases at the expense of scintillation luminescence efficiency.Meanwhile,although Sc_(2)O_(3):Eu presents much lower afterglow intensity than Lu_(2)O_(3):Eu,the addition of Sc_(2)O_(3)will just increase the afterglow level of the(Lu1-yScy)_(2)O_(3):5 at%Eu single crystal system.Possible mechanisms for above phenomena are discussed based on experimental results.展开更多
基金Project supported by the National Natural Science Foundation of China (10904131)
文摘One-dimensional Lu2O3:Eu3+ nanofibers were prepared by electrospinning followed by high-temperature calcinations.Thermogravimetric and differential thermal analysis,X-ray powder diffraction,Fourier transform infrared spectroscopy,scanning electron microscopy,photoluminescent spectra and decay curves were used to characterize the samples.Results showed that samples began to crystallize at ～500 oC and crystallized completely around 1000 oC.The average diameter of nanofibers(1000 oC annealed) was about 55 nm and the particle size of Lu2O3:Eu3+ increased with increasing annealing temperature.Under ultraviolet excitation,nanofibers exhibited typical red emission of Eu3+ in Lu2O3.The effect of heat-treatment temperature on luminescent properties of nanofibers was also discussed.
基金supported by National Natural Science Foundation of China(12175130,11875187)the Opening Project of State Key Laboratory of Key Laboratory of Transparent Opto-functional Inorganic Materials,Chinese Academy of Sciences(KLTOIM202002)。
文摘In this paper,effect of two strategies on afterglow behavior of Lu_(2)O_(3):Eu single crystal scintillato r,Pr^(3+)codoping and solid solution with Sc_(2)O_(3),were studied systematically.Two groups of Lu_(2)O_(3):5 at%Eu,x at%Pr(x=0,0.2,0.5,1,2 and 5)and(Lu1-yScy)_(2)O_(3):5 at%Eu(y=0,20 at%,50 at%and 70 at%)single crystals were grown by floating zone(FZ)method in air atmosphere.The structures of as-grown crystals were determined by X-ray diffraction(XRD).The scintillation,photoluminescence properties and carrier trap states were investigated through afterglow,X-ray excitation luminescence(XEL),transmittance,photoluminescence excitation(PLE)and photoluminescence(PL),PL decay and thermal stimulated luminescence(TSL)curves.It is found that with the increase of Pr^(3+)concentration,the afterglow level of the system decreases at the expense of scintillation luminescence efficiency.Meanwhile,although Sc_(2)O_(3):Eu presents much lower afterglow intensity than Lu_(2)O_(3):Eu,the addition of Sc_(2)O_(3)will just increase the afterglow level of the(Lu1-yScy)_(2)O_(3):5 at%Eu single crystal system.Possible mechanisms for above phenomena are discussed based on experimental results.
