Four 16.7 km-long tunnels with diameters ranging from 12.4 to 14.6 m are now under construction at Jinping II hydropower station along the Yalong River.The tunnels pass through Triassic rocks below Jinping Mountain.Th...Four 16.7 km-long tunnels with diameters ranging from 12.4 to 14.6 m are now under construction at Jinping II hydropower station along the Yalong River.The tunnels pass through Triassic rocks below Jinping Mountain.The tunnels are characterized with high overburden,long alignment and complex geological conditions.Brittle failure in marble and squeezing in schist are the primary problems in tunnelling.This paper introduces the studies of laboratory tests on Jinping II marble as well as numerical prediction of excavation damaged zone (EDZ) of tunnel section in brittle marble and determination of reinforced concrete lining thickness for restraining time-dependent deformation in the schist tunnel section.Laboratory tests indicate that Jinping II marble presents a complex brittle-ductile-plastic transition behavior of post-peak response with increasing confining pressure.Such behavior can be described numerically with the Hoek-Brown model.The EDZ was calibrated and predicted using both fast Lagrangian analysis of continua (FLAC) and particle flow code (PFC).The predicted result of EDZ in sections with different qualities of rock mass under various overburden pressures is quite helpful in understanding EDZ characterization and support design.A power-law creep model was used to support the lining design,especially in determining the lining thickness.Field convergence measurement data over 19 months were used to calibrate the creep model properties,followed by a sensibility analysis of reinforced concrete lining thickness that was launched to present the maximum lining compressive stress.展开更多
Deep underground excavations within hard rocks can result in damage to the surrounding rock mass mostly due to redistribution of stresses.Especially within rock masses with non-persistent joints,the role of the pre-ex...Deep underground excavations within hard rocks can result in damage to the surrounding rock mass mostly due to redistribution of stresses.Especially within rock masses with non-persistent joints,the role of the pre-existing joints in the damage evolution around the underground opening is of critical importance as they govern the fracturing mechanisms and influence the brittle responses of these hard rock masses under highly anisotropic in situ stresses.In this study,the main focus is the impact of joint network geometry,joint strength and applied field stresses on the rock mass behaviours and the evolution of excavation induced damage due to the loss of confinement as a tunnel face advances.Analysis of such a phenomenon was conducted using the finite-discrete element method (FDEM).The numerical model is initially calibrated in order to match the behaviour of the fracture-free,massive Lac du Bonnet granite during the excavation of the Underground Research Laboratory (URL) Test Tunnel,Canada.The influence of the pre-existing joints on the rock mass response during excavation is investigated by integrating discrete fracture networks (DFNs) of various characteristics into the numerical models under varying in situ stresses.The numerical results obtained highlight the significance of the pre-existing joints on the reduction of in situ rock mass strength and its capacity for extension with both factors controlling the brittle response of the material.Furthermore,the impact of spatial distribution of natural joints on the stability of an underground excavation is discussed,as well as the potentially minor influence of joint strength on the stress induced damage within joint systems of a non-persistent nature under specific conditions.Additionally,the in situ stress-joint network interaction is examined,revealing the complex fracturing mechanisms that may lead to uncontrolled fracture propagation that compromises the overall stability of an underground excavation.展开更多
Over the past twenty years, there has been a growing interest in the development of numerical modelsthat can realistically capture the progressive failure of rock masses. In particular, the investigation ofdamage deve...Over the past twenty years, there has been a growing interest in the development of numerical modelsthat can realistically capture the progressive failure of rock masses. In particular, the investigation ofdamage development around underground excavations represents a key issue in several rock engineeringapplications, including tunnelling, mining, drilling, hydroelectric power generation, and the deepgeological disposal of nuclear waste. The goal of this paper is to show the effectiveness of a hybrid finitediscreteelement method （FDEM） code to simulate the fracturing mechanisms associated with theexcavation of underground openings in brittle rock formations. A brief review of the current state-of-theartmodelling approaches is initially provided, including the description of selecting continuum- anddiscontinuum-based techniques. Then, the influence of a number of factors, including mechanical and insitu stress anisotropy, as well as excavation geometry, on the simulated damage is analysed for threedifferent geomechanical scenarios. Firstly, the fracture nucleation and growth process under isotropicrock mass conditions is simulated for a circular shaft. Secondly, the influence of mechanical anisotropy onthe development of an excavation damaged zone （EDZ） around a tunnel excavated in a layered rockformation is considered. Finally, the interaction mechanisms between two large caverns of an undergroundhydroelectric power station are investigated, with particular emphasis on the rock mass responsesensitivity to the pillar width and excavation sequence. Overall, the numerical results indicate that FDEMsimulations can provide unique geomechanical insights in cases where an explicit consideration offracture and fragmentation processes is of paramount importance. 2014 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences. Production and hosting byElsevier B.V. All rights reserved.展开更多
This paper focuses on the formation mechanism of fractures induced by excavation of a gallery in soft sedimentary rocks in the Horonobe area of Japan. Detailed fracture mapping of the gallery indicates that the fractu...This paper focuses on the formation mechanism of fractures induced by excavation of a gallery in soft sedimentary rocks in the Horonobe area of Japan. Detailed fracture mapping of the gallery indicates that the fractures consist of both pre-existing shear fractures and excavation damaged zone （EDZ） fractures. EDZ fractures correspond to weak planes associated with bedding planes or transgranular cracks. The EDZ fractures terminate against pre-existing shear fractures. Therefore, even for excavations in soft sedimentary rocks, formation of the EDZ fractures are controlled by pre-existing fractures and earlier weak planes.展开更多
In this paper, the coupled thermo-mechanical （TM） processes in the AEspoe Pillar Stability Experiment （APSE） carried out by the Swedish Nuclear Fuel and Waste Management Company （SKB） were simulated using both c...In this paper, the coupled thermo-mechanical （TM） processes in the AEspoe Pillar Stability Experiment （APSE） carried out by the Swedish Nuclear Fuel and Waste Management Company （SKB） were simulated using both continuum and discontinuum based numerical methods. Two-dimensional （2D） and three- dimensional （3D） finite element method （FEM） and 2D distinct element method （DEM） with particles were used. The main objective for the large scale in situ experiment is to investigate the yielding strength of crystalline rock and the formation of the excavation disturbed/damaged zone （EDZ） during excavation of two boreholes, pressurizing of one of the boreholes and heating. For the DEM simulations, the heat flow algorithm was newly introduced into the original code. The calculated stress, displacement and temperature distributions were compared with the ones obtained from in situ measurements and FEM simulations. A parametric study for initial microcracks was also performed to reproduce the spalling phenomena observed in the APSE.展开更多
基金Support by the China Postdoctor Fund (20100471757)
文摘Four 16.7 km-long tunnels with diameters ranging from 12.4 to 14.6 m are now under construction at Jinping II hydropower station along the Yalong River.The tunnels pass through Triassic rocks below Jinping Mountain.The tunnels are characterized with high overburden,long alignment and complex geological conditions.Brittle failure in marble and squeezing in schist are the primary problems in tunnelling.This paper introduces the studies of laboratory tests on Jinping II marble as well as numerical prediction of excavation damaged zone (EDZ) of tunnel section in brittle marble and determination of reinforced concrete lining thickness for restraining time-dependent deformation in the schist tunnel section.Laboratory tests indicate that Jinping II marble presents a complex brittle-ductile-plastic transition behavior of post-peak response with increasing confining pressure.Such behavior can be described numerically with the Hoek-Brown model.The EDZ was calibrated and predicted using both fast Lagrangian analysis of continua (FLAC) and particle flow code (PFC).The predicted result of EDZ in sections with different qualities of rock mass under various overburden pressures is quite helpful in understanding EDZ characterization and support design.A power-law creep model was used to support the lining design,especially in determining the lining thickness.Field convergence measurement data over 19 months were used to calibrate the creep model properties,followed by a sensibility analysis of reinforced concrete lining thickness that was launched to present the maximum lining compressive stress.
基金the Natural Sciences and Engineering Research Council of Canadathe Ministry of National Defensethe RMC Green Team for providing the funding and the resources
文摘Deep underground excavations within hard rocks can result in damage to the surrounding rock mass mostly due to redistribution of stresses.Especially within rock masses with non-persistent joints,the role of the pre-existing joints in the damage evolution around the underground opening is of critical importance as they govern the fracturing mechanisms and influence the brittle responses of these hard rock masses under highly anisotropic in situ stresses.In this study,the main focus is the impact of joint network geometry,joint strength and applied field stresses on the rock mass behaviours and the evolution of excavation induced damage due to the loss of confinement as a tunnel face advances.Analysis of such a phenomenon was conducted using the finite-discrete element method (FDEM).The numerical model is initially calibrated in order to match the behaviour of the fracture-free,massive Lac du Bonnet granite during the excavation of the Underground Research Laboratory (URL) Test Tunnel,Canada.The influence of the pre-existing joints on the rock mass response during excavation is investigated by integrating discrete fracture networks (DFNs) of various characteristics into the numerical models under varying in situ stresses.The numerical results obtained highlight the significance of the pre-existing joints on the reduction of in situ rock mass strength and its capacity for extension with both factors controlling the brittle response of the material.Furthermore,the impact of spatial distribution of natural joints on the stability of an underground excavation is discussed,as well as the potentially minor influence of joint strength on the stress induced damage within joint systems of a non-persistent nature under specific conditions.Additionally,the in situ stress-joint network interaction is examined,revealing the complex fracturing mechanisms that may lead to uncontrolled fracture propagation that compromises the overall stability of an underground excavation.
基金supported by the Natural Science and Engineering Research Council (NSERC) of Canada in the form of discovery grant No. 341275the Swiss National Cooperative for the Disposal of Radioactive Waste (NAGRA)
文摘Over the past twenty years, there has been a growing interest in the development of numerical modelsthat can realistically capture the progressive failure of rock masses. In particular, the investigation ofdamage development around underground excavations represents a key issue in several rock engineeringapplications, including tunnelling, mining, drilling, hydroelectric power generation, and the deepgeological disposal of nuclear waste. The goal of this paper is to show the effectiveness of a hybrid finitediscreteelement method （FDEM） code to simulate the fracturing mechanisms associated with theexcavation of underground openings in brittle rock formations. A brief review of the current state-of-theartmodelling approaches is initially provided, including the description of selecting continuum- anddiscontinuum-based techniques. Then, the influence of a number of factors, including mechanical and insitu stress anisotropy, as well as excavation geometry, on the simulated damage is analysed for threedifferent geomechanical scenarios. Firstly, the fracture nucleation and growth process under isotropicrock mass conditions is simulated for a circular shaft. Secondly, the influence of mechanical anisotropy onthe development of an excavation damaged zone （EDZ） around a tunnel excavated in a layered rockformation is considered. Finally, the interaction mechanisms between two large caverns of an undergroundhydroelectric power station are investigated, with particular emphasis on the rock mass responsesensitivity to the pillar width and excavation sequence. Overall, the numerical results indicate that FDEMsimulations can provide unique geomechanical insights in cases where an explicit consideration offracture and fragmentation processes is of paramount importance. 2014 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences. Production and hosting byElsevier B.V. All rights reserved.
文摘This paper focuses on the formation mechanism of fractures induced by excavation of a gallery in soft sedimentary rocks in the Horonobe area of Japan. Detailed fracture mapping of the gallery indicates that the fractures consist of both pre-existing shear fractures and excavation damaged zone （EDZ） fractures. EDZ fractures correspond to weak planes associated with bedding planes or transgranular cracks. The EDZ fractures terminate against pre-existing shear fractures. Therefore, even for excavations in soft sedimentary rocks, formation of the EDZ fractures are controlled by pre-existing fractures and earlier weak planes.
基金conducted within the context of the international DECOVALEX Project (DEvelopment of COupled models and their VALidation against EXperiments)financed by Japan Atomic Energy Agency (JAEA) who was also one of the Funding Organizations of the projectChrister Anders-son from Swedish Nuclear Fuel and Waste Management Co.(SKB),Sweden
文摘In this paper, the coupled thermo-mechanical （TM） processes in the AEspoe Pillar Stability Experiment （APSE） carried out by the Swedish Nuclear Fuel and Waste Management Company （SKB） were simulated using both continuum and discontinuum based numerical methods. Two-dimensional （2D） and three- dimensional （3D） finite element method （FEM） and 2D distinct element method （DEM） with particles were used. The main objective for the large scale in situ experiment is to investigate the yielding strength of crystalline rock and the formation of the excavation disturbed/damaged zone （EDZ） during excavation of two boreholes, pressurizing of one of the boreholes and heating. For the DEM simulations, the heat flow algorithm was newly introduced into the original code. The calculated stress, displacement and temperature distributions were compared with the ones obtained from in situ measurements and FEM simulations. A parametric study for initial microcracks was also performed to reproduce the spalling phenomena observed in the APSE.
