Dynamic Reactive Power Optimization(DRPO) is a large-scale, multi-period, and strongly coupled nonlinear mixed-integer programming problem that is difficult to solve directly. First, to handle discrete variables and s...Dynamic Reactive Power Optimization(DRPO) is a large-scale, multi-period, and strongly coupled nonlinear mixed-integer programming problem that is difficult to solve directly. First, to handle discrete variables and switching operation constraints, DRPO is formulated as a nonlinear constrained two-objective optimization problem in this paper. The first objective is to minimize the real power loss and the Total Voltage Deviations(TVDs), and the second objective is to minimize incremental system loss. Then a Filter Collaborative State Transition Algorithm(FCSTA) is presented for solving DRPO problems. Two populations corresponding to two different objectives are employed. Moreover, the filter technique is utilized to deal with constraints. Finally, the effectiveness of the proposed method is demonstrated through the results obtained for a 24-hour test on Ward & Hale 6 bus, IEEE 14 bus, and IEEE 30 bus test power systems. To substantiate the effectiveness of the proposed algorithms, the obtained results are compared with different approaches in the literature.展开更多
Power flow analysis is a numerical way of study of behavior of flow of electric power in an interconnected system. In order to meet the growing demands of electrical energy in an optimum way, there is a need to upgrad...Power flow analysis is a numerical way of study of behavior of flow of electric power in an interconnected system. In order to meet the growing demands of electrical energy in an optimum way, there is a need to upgrade existing systems or to install new systems. Therefore, planning of new installations and determination of best operating conditions of existing systems need power flow analysis. In this way, cost/benefit ratio for both suppliers and customers is maintained. This research involves the design and power flow analysis of IEEE-14 bus system. Newton Raphson method is applied for better efficiency and reduced computational time. Simulation analysis is conducted in ETAP software because of its excessive used in real life systems.展开更多
In this paper, an interline power flow controller （IPFC） is used for controlling multi transmission lines. However, the optimal placement of IPFC in the transmis-sion line is a major problem. Thus, we use a combinat...In this paper, an interline power flow controller （IPFC） is used for controlling multi transmission lines. However, the optimal placement of IPFC in the transmis-sion line is a major problem. Thus, we use a combination of tabu search （TS） algorithm and artificial neural network （ANN） in the proposed method to find out the best placement locations for IPFC in a given multi transmission line system. TS algorithm is an optimization algorithm and we use it in the proposed method to determine the optimum bus combination using line data. Then, using the optimum bus combination, the neural network is trained to find out the best placement locations for IPFC. Finally, IPFC is connected at the best locations indicated by the neural network. Furthermore, using Newton-Raphson load flow algorithm, the transmission line loss of the IPFC connected bus is analyzed. The proposed methodology is implemen- ted in MATLAB working platform and tested on the IEEE-14 bus system. The output is compared with the genetic algorithm （GA） and general load flow analysis. The results are validated with Levenberg-Marquardt back propagation and gradient descent with momentum network training algorithm.展开更多
Controlling voltage and active or reactive losses are one of the most important issues in each power grid.In this paper,the influence of wind farm and thyristors switched capacitors on the network are considered.TSSC ...Controlling voltage and active or reactive losses are one of the most important issues in each power grid.In this paper,the influence of wind farm and thyristors switched capacitors on the network are considered.TSSC and Wind turbines are one of the significant components of each network.These instruments are also one of the resources of producing active and reactive power.In this study,wind farm and TSSC are already located optimally by Genetic algorithm.This network studied when a fault considered in one of buses.So that,in first step none of wind farm and TSSC are in the power grid.In the second step,both wind farm and TSSC are connected while a short circuit accrues in one of the busses or lines of the network.At the end,it will be observed that using thyristor switched capacitors and wind farm influence the network.So that,the capacity of producing the reactive and active power will be increased and totally the loss of the system will be decreased.Furthermore,the voltage profile will be in a suitable range.展开更多
基金supported by the National Natural Science Foundation of China(Nos.51767022 and 51575469)
文摘Dynamic Reactive Power Optimization(DRPO) is a large-scale, multi-period, and strongly coupled nonlinear mixed-integer programming problem that is difficult to solve directly. First, to handle discrete variables and switching operation constraints, DRPO is formulated as a nonlinear constrained two-objective optimization problem in this paper. The first objective is to minimize the real power loss and the Total Voltage Deviations(TVDs), and the second objective is to minimize incremental system loss. Then a Filter Collaborative State Transition Algorithm(FCSTA) is presented for solving DRPO problems. Two populations corresponding to two different objectives are employed. Moreover, the filter technique is utilized to deal with constraints. Finally, the effectiveness of the proposed method is demonstrated through the results obtained for a 24-hour test on Ward & Hale 6 bus, IEEE 14 bus, and IEEE 30 bus test power systems. To substantiate the effectiveness of the proposed algorithms, the obtained results are compared with different approaches in the literature.
文摘Power flow analysis is a numerical way of study of behavior of flow of electric power in an interconnected system. In order to meet the growing demands of electrical energy in an optimum way, there is a need to upgrade existing systems or to install new systems. Therefore, planning of new installations and determination of best operating conditions of existing systems need power flow analysis. In this way, cost/benefit ratio for both suppliers and customers is maintained. This research involves the design and power flow analysis of IEEE-14 bus system. Newton Raphson method is applied for better efficiency and reduced computational time. Simulation analysis is conducted in ETAP software because of its excessive used in real life systems.
文摘In this paper, an interline power flow controller （IPFC） is used for controlling multi transmission lines. However, the optimal placement of IPFC in the transmis-sion line is a major problem. Thus, we use a combination of tabu search （TS） algorithm and artificial neural network （ANN） in the proposed method to find out the best placement locations for IPFC in a given multi transmission line system. TS algorithm is an optimization algorithm and we use it in the proposed method to determine the optimum bus combination using line data. Then, using the optimum bus combination, the neural network is trained to find out the best placement locations for IPFC. Finally, IPFC is connected at the best locations indicated by the neural network. Furthermore, using Newton-Raphson load flow algorithm, the transmission line loss of the IPFC connected bus is analyzed. The proposed methodology is implemen- ted in MATLAB working platform and tested on the IEEE-14 bus system. The output is compared with the genetic algorithm （GA） and general load flow analysis. The results are validated with Levenberg-Marquardt back propagation and gradient descent with momentum network training algorithm.
文摘Controlling voltage and active or reactive losses are one of the most important issues in each power grid.In this paper,the influence of wind farm and thyristors switched capacitors on the network are considered.TSSC and Wind turbines are one of the significant components of each network.These instruments are also one of the resources of producing active and reactive power.In this study,wind farm and TSSC are already located optimally by Genetic algorithm.This network studied when a fault considered in one of buses.So that,in first step none of wind farm and TSSC are in the power grid.In the second step,both wind farm and TSSC are connected while a short circuit accrues in one of the busses or lines of the network.At the end,it will be observed that using thyristor switched capacitors and wind farm influence the network.So that,the capacity of producing the reactive and active power will be increased and totally the loss of the system will be decreased.Furthermore,the voltage profile will be in a suitable range.
