Li-rich layered oxides have become one of the most concerned cathode materials for high-energy lithiumion batteries, but they still suffer from poor cycling stability and detrimental voltage decay, especially at eleva...Li-rich layered oxides have become one of the most concerned cathode materials for high-energy lithiumion batteries, but they still suffer from poor cycling stability and detrimental voltage decay, especially at elevated temperature. Herein, we proposed a surface heterophase coating engineering based on amorphous/crystalline Li3 PO4 to address these issues for Li-rich layered oxides via a facile wet chemical method. The heterophase coating layer combines the advantages of physical barrier effect achieved by amorphous Li3 PO4 with facilitated Li+diffusion stemmed from crystalline Li3 PO4. Consequently, the modified Li(1.2) Ni(0.2) Mn(0.6) O2 delivers higher initial coulombic efficiency of 92% with enhanced cycling stability at 55 °C(192.9 mAh/g after 100 cycles at 1 C). More importantly, the intrinsic voltage decay has been inhibited as well, i.e. the average potential drop per cycle decreases from 5.96 mV to 2.99 mV. This surface heterophase coating engineering provides an effective strategy to enhance the high-temperature electrochemical performances of Li-rich layered oxides and guides the direction of surface modification strategies for cathode materials in the future.展开更多
The SrB4O7：Sm2＋ phosphor was synthesized by high temperature solid state reaction method. The phosphor-in-glass was prepared by mixing and firing the phosphor and TeO2-ZnO glass precursor. The XRD results showed tha...The SrB4O7：Sm2＋ phosphor was synthesized by high temperature solid state reaction method. The phosphor-in-glass was prepared by mixing and firing the phosphor and TeO2-ZnO glass precursor. The XRD results showed that the phosphor-in-glass was in amorphous phase because of the tiny mass fraction of phosphor in glass. The emission spectrum under the 355 nm excitation was measured, and it exhibited the same characteristic emission peaks as the phosphor sample. The temperature characteristic of the SrB4O7：Sm2＋ phosphor-in-glass was discussed by analyzing the lifetime of 684 nm emission at various temperatures. The relative temperature sensitivity of 5%/K around 573 K was obtained for the temperature dependent lifetime, suggesting that the material in this study is a promising candidate for temperature sensor application.展开更多
In this article,we investigate the dependence of nuclear temperature on emitting source neutron-proton(N/Z)asymmetry with light charged particles(LCPs)and intermediate mass fragments(IMFs)generated from intermediate-v...In this article,we investigate the dependence of nuclear temperature on emitting source neutron-proton(N/Z)asymmetry with light charged particles(LCPs)and intermediate mass fragments(IMFs)generated from intermediate-velocity sources in thirteen reaction systems with different N/Z asymmetries,^(64)Zn on^(112)Sn,and^(70)Zn,^(64)Ni on^(112,124)Sn,^(58,64)Ni,^(197)Au,and^(232)Th at 40 MeV/nucleon.The apparent temperature values of LCPs and IMFs from different systems are deduced from the measured yields using two helium-related and eight carbon-related double isotope ratio thermometers,respectively.Then,the sequential decay effect on the experimental apparent temperature deduction with the double isotope ratio thermometers is quantitatively corrected explicitly with the aid of the quantum statistical model.The present treatment is an improvement compared to our previous studies in which an indirect method was adopted to qualitatively consider the sequential decay effect.A negligible N/Z asymmetry dependence of the real temperature after the correction is quantitatively addressed in heavy-ion reactions at the present intermediate energy,where a change of o.1 units in source N/Z asymmetry corresponds to an absolute change in temperature of an order of 0.03 to 0.29 MeV on average for LCPs and IMFs.This conclusion is in close agreement with that inferred qualitatively via the indirect method in our previous studies.展开更多
基金supported by the National Key R&D Program of China (2016YFB0100301)the National Natural Science Foundation of China (51802020, 51802019)+1 种基金the Beijing Institute of Technology Research Fund Program for Young Scholarsthe Young Elite Scientists Sponsorship Program by CAST (2018QNRC001。
文摘Li-rich layered oxides have become one of the most concerned cathode materials for high-energy lithiumion batteries, but they still suffer from poor cycling stability and detrimental voltage decay, especially at elevated temperature. Herein, we proposed a surface heterophase coating engineering based on amorphous/crystalline Li3 PO4 to address these issues for Li-rich layered oxides via a facile wet chemical method. The heterophase coating layer combines the advantages of physical barrier effect achieved by amorphous Li3 PO4 with facilitated Li+diffusion stemmed from crystalline Li3 PO4. Consequently, the modified Li(1.2) Ni(0.2) Mn(0.6) O2 delivers higher initial coulombic efficiency of 92% with enhanced cycling stability at 55 °C(192.9 mAh/g after 100 cycles at 1 C). More importantly, the intrinsic voltage decay has been inhibited as well, i.e. the average potential drop per cycle decreases from 5.96 mV to 2.99 mV. This surface heterophase coating engineering provides an effective strategy to enhance the high-temperature electrochemical performances of Li-rich layered oxides and guides the direction of surface modification strategies for cathode materials in the future.
基金supported by the National Key Basic Research Program of China(2013CB921800)the National Natural Science Foundation of China(11274299,11374291,11574298,11404321)Anhui Provincial Natural Science Foundation(1308085QE75)
文摘The SrB4O7：Sm2＋ phosphor was synthesized by high temperature solid state reaction method. The phosphor-in-glass was prepared by mixing and firing the phosphor and TeO2-ZnO glass precursor. The XRD results showed that the phosphor-in-glass was in amorphous phase because of the tiny mass fraction of phosphor in glass. The emission spectrum under the 355 nm excitation was measured, and it exhibited the same characteristic emission peaks as the phosphor sample. The temperature characteristic of the SrB4O7：Sm2＋ phosphor-in-glass was discussed by analyzing the lifetime of 684 nm emission at various temperatures. The relative temperature sensitivity of 5%/K around 573 K was obtained for the temperature dependent lifetime, suggesting that the material in this study is a promising candidate for temperature sensor application.
基金Supported by the National Natural Science Foundation of China(12275186,11705242,12175156,11805138,11905120)the Fundamental Research Funds For the Central Universities in China(YJ201954,YJ201820)。
文摘In this article,we investigate the dependence of nuclear temperature on emitting source neutron-proton(N/Z)asymmetry with light charged particles(LCPs)and intermediate mass fragments(IMFs)generated from intermediate-velocity sources in thirteen reaction systems with different N/Z asymmetries,^(64)Zn on^(112)Sn,and^(70)Zn,^(64)Ni on^(112,124)Sn,^(58,64)Ni,^(197)Au,and^(232)Th at 40 MeV/nucleon.The apparent temperature values of LCPs and IMFs from different systems are deduced from the measured yields using two helium-related and eight carbon-related double isotope ratio thermometers,respectively.Then,the sequential decay effect on the experimental apparent temperature deduction with the double isotope ratio thermometers is quantitatively corrected explicitly with the aid of the quantum statistical model.The present treatment is an improvement compared to our previous studies in which an indirect method was adopted to qualitatively consider the sequential decay effect.A negligible N/Z asymmetry dependence of the real temperature after the correction is quantitatively addressed in heavy-ion reactions at the present intermediate energy,where a change of o.1 units in source N/Z asymmetry corresponds to an absolute change in temperature of an order of 0.03 to 0.29 MeV on average for LCPs and IMFs.This conclusion is in close agreement with that inferred qualitatively via the indirect method in our previous studies.
