Four different welding sequences of double-pulse MIG welding were conducted for 6061-T6 aluminum alloy automobile bumpers by using nonlinear elastoplasticity finite element method based on ABAQUS software.The post-wel...Four different welding sequences of double-pulse MIG welding were conducted for 6061-T6 aluminum alloy automobile bumpers by using nonlinear elastoplasticity finite element method based on ABAQUS software.The post-welding residual stress and deformation were definitely different among the four welding sequences.The results showed that the highest temperature in Solution A was approximately 200℃higher than the melting point of base metal.High residual stress was resulted from this large temperature gradient and mainly concentrated on the welding vicinity between beam and crash box.The welding deformation primarily occurred in both of the contraction of two-ends of the beam and the self-contraction of crash box.Compared with other welding sequences,the residual stress in Solution A was the smallest,whereas the welding deformation was the largest.However,the optimal sequence was Solution B because of the effective reduction of residual stress and good assembly requirements.展开更多
A 3-D finite element model is developed to predict the temperature field and thermally induced residual stress and distortion in laser＋GMAW hybrid welding of 6061-T6 aluminum alloy T-joint. And the characteristics of...A 3-D finite element model is developed to predict the temperature field and thermally induced residual stress and distortion in laser＋GMAW hybrid welding of 6061-T6 aluminum alloy T-joint. And the characteristics of residual stress distribution and deformation are numerically investigated. In the simulation, the heat source model takes into account the effect of joint geometric shape and welding torch slant on the heat flux distribution and a sequentially coupled thermo-mechanical method is used. The calculated results show that higher residual stress is distributed in and surround the weld zone. Its peak value is very close to the yield strength of base metal. Besides, a large deformation appears in the middle and rear part of the weldment.展开更多
基金Projects(31665004,31715011) supported by the Open Fund of State Key Laboratory of Advanced Design and Manufacture for Vehicle Body,Hunan University,ChinaProject(15C0450) supported by the Educational Commission of Hunan Province of China
文摘Four different welding sequences of double-pulse MIG welding were conducted for 6061-T6 aluminum alloy automobile bumpers by using nonlinear elastoplasticity finite element method based on ABAQUS software.The post-welding residual stress and deformation were definitely different among the four welding sequences.The results showed that the highest temperature in Solution A was approximately 200℃higher than the melting point of base metal.High residual stress was resulted from this large temperature gradient and mainly concentrated on the welding vicinity between beam and crash box.The welding deformation primarily occurred in both of the contraction of two-ends of the beam and the self-contraction of crash box.Compared with other welding sequences,the residual stress in Solution A was the smallest,whereas the welding deformation was the largest.However,the optimal sequence was Solution B because of the effective reduction of residual stress and good assembly requirements.
基金supported by the Sino-Russian Cooperation Research Project of China (No. 2009DFR50170)the National Natural Science Foundation of China (No.51105182)the College Natural Science Foundation of Jiangsu Province (No. 11KJB460004)
文摘A 3-D finite element model is developed to predict the temperature field and thermally induced residual stress and distortion in laser＋GMAW hybrid welding of 6061-T6 aluminum alloy T-joint. And the characteristics of residual stress distribution and deformation are numerically investigated. In the simulation, the heat source model takes into account the effect of joint geometric shape and welding torch slant on the heat flux distribution and a sequentially coupled thermo-mechanical method is used. The calculated results show that higher residual stress is distributed in and surround the weld zone. Its peak value is very close to the yield strength of base metal. Besides, a large deformation appears in the middle and rear part of the weldment.
