In this article,studies on the multimode excitation problem of waveguides and antennas,the balance/unbalance mech-anism and the balanced feeding techniques in dipole antenna systems are first briefly historically revi...In this article,studies on the multimode excitation problem of waveguides and antennas,the balance/unbalance mech-anism and the balanced feeding techniques in dipole antenna systems are first briefly historically reviewed.In this context,general-ized odd-even mode theory is advanced to quantitatively and approximately describe the mutual coupling effect between a feed line and an antenna.As is mathematically deduced and demonstrated,the modal parity mismatch between the feed line and the antenna should ultimately dominate the unbalance phenomenon in antenna systems.Thus,an elegant,closed-form formula is derived to ap-proximately calculate the“unbalance degree”of a straight dipole off-center fed by a symmetric twin-wire line.Design approaches for the simplest,linear,1-D multimode resonant antennas are introduced.Moreover,the“falling tone excitation”law gauged based on prototype dipoles is revealed and used to develop a mode synthesis design approach for microstrip patch antennas(MPAs)and 2-D sectorial electric dipole antennas.Design examples with distinctive radiation performance are presented and discussed.Finally,possible development trends of multimode resonant antennas are prospected.展开更多
A fully-differential charge pump（FDCP）with perfect current matching and low output current noise is realized for phase-locked loops（PLLs）.An easily stable common-mode feedback（CMFB）circuit which can handle high ...A fully-differential charge pump（FDCP）with perfect current matching and low output current noise is realized for phase-locked loops（PLLs）.An easily stable common-mode feedback（CMFB）circuit which can handle high input voltage swing is proposed.Current mismatch and current noise contribution from the CMFB circuit is minimized.In order to optimize PLL phase noise,the output current noise of the FDCP is analyzed in detail and calculated with the sampling principle.The calculation result agrees well with the simulation.Based on the noise analysis,many methods to lower output current noise of the FDCP are discussed.The fully-differential charge pump is integrated into a 1–2 GHz frequency synthesizer and fabricated in an SMIC CMOS 0.18μm process.The measured output reference spur is–64 dBc to–69 dBc.The in-band and out-band phase noise is–95 dBc/Hz at 3 kHz frequency offset and–123 dBc/Hz at 1 MHz frequency offset respectively.展开更多
The paper presents finite element modeling of crack tip blunting for numerical estimation of fracture parameter of a Mode I crack, in weak alloy steel, which is near and normal to the interface of elastically identica...The paper presents finite element modeling of crack tip blunting for numerical estimation of fracture parameter of a Mode I crack, in weak alloy steel, which is near and normal to the interface of elastically identical but stronger maraging steel. The bimetallic body is subjected to monotonic load in K dominated regime. Crack tip yield zone across the interface, treated as Dugdale’s cohesive zone, is isolated from the bimetallic domain and is modeled alone under the action of respective cohesive stress over yield zones for obtaining the contribution of mismatch between yield strength of the steels in crack energy release rate component, Jinterface. Effect of far field load on Jinterface is found separately from a theoretical model. Numerical and theoretical results of Jinterface are in good agreement.展开更多
基金supported by the National Key Research and Development Program of China(Grant No.2021YFE0205900)the Key Technologies R&D Program of Jiangsu(Prospective and Key Technologies for Industry)(Grant Nos.BE2022067 and BE2022067-2)。
文摘In this article,studies on the multimode excitation problem of waveguides and antennas,the balance/unbalance mech-anism and the balanced feeding techniques in dipole antenna systems are first briefly historically reviewed.In this context,general-ized odd-even mode theory is advanced to quantitatively and approximately describe the mutual coupling effect between a feed line and an antenna.As is mathematically deduced and demonstrated,the modal parity mismatch between the feed line and the antenna should ultimately dominate the unbalance phenomenon in antenna systems.Thus,an elegant,closed-form formula is derived to ap-proximately calculate the“unbalance degree”of a straight dipole off-center fed by a symmetric twin-wire line.Design approaches for the simplest,linear,1-D multimode resonant antennas are introduced.Moreover,the“falling tone excitation”law gauged based on prototype dipoles is revealed and used to develop a mode synthesis design approach for microstrip patch antennas(MPAs)and 2-D sectorial electric dipole antennas.Design examples with distinctive radiation performance are presented and discussed.Finally,possible development trends of multimode resonant antennas are prospected.
基金supported by the National High Technology Research and Development Program of China(No.2007AA01Z282)the National Natural Science Foundation of China(No.60876019)
文摘A fully-differential charge pump（FDCP）with perfect current matching and low output current noise is realized for phase-locked loops（PLLs）.An easily stable common-mode feedback（CMFB）circuit which can handle high input voltage swing is proposed.Current mismatch and current noise contribution from the CMFB circuit is minimized.In order to optimize PLL phase noise,the output current noise of the FDCP is analyzed in detail and calculated with the sampling principle.The calculation result agrees well with the simulation.Based on the noise analysis,many methods to lower output current noise of the FDCP are discussed.The fully-differential charge pump is integrated into a 1–2 GHz frequency synthesizer and fabricated in an SMIC CMOS 0.18μm process.The measured output reference spur is–64 dBc to–69 dBc.The in-band and out-band phase noise is–95 dBc/Hz at 3 kHz frequency offset and–123 dBc/Hz at 1 MHz frequency offset respectively.
文摘The paper presents finite element modeling of crack tip blunting for numerical estimation of fracture parameter of a Mode I crack, in weak alloy steel, which is near and normal to the interface of elastically identical but stronger maraging steel. The bimetallic body is subjected to monotonic load in K dominated regime. Crack tip yield zone across the interface, treated as Dugdale’s cohesive zone, is isolated from the bimetallic domain and is modeled alone under the action of respective cohesive stress over yield zones for obtaining the contribution of mismatch between yield strength of the steels in crack energy release rate component, Jinterface. Effect of far field load on Jinterface is found separately from a theoretical model. Numerical and theoretical results of Jinterface are in good agreement.
