为了研究表面形貌对线接触弹流状态下摩擦副摩擦特性的影响,采用激光微造型技术,通过控制微造型的形状、深度、间距和面积占有率等参数制造了两组表面高度算术平均值Sa分别相同的试件.使用Talysurf CCI Lite非接触式三维光学轮廓仪对表...为了研究表面形貌对线接触弹流状态下摩擦副摩擦特性的影响,采用激光微造型技术,通过控制微造型的形状、深度、间距和面积占有率等参数制造了两组表面高度算术平均值Sa分别相同的试件.使用Talysurf CCI Lite非接触式三维光学轮廓仪对表面进行测量,采用ISO25178参数及连通性系数Us对测量表面进行表征,最后在JPM-1型双盘摩擦磨损试验机上对试件进行富油摩擦试验,得到不同转速、不同载荷工况下的摩擦系数.结果表明:线接触状态下,微造型形状、方向及深度均会对表面的摩擦特性产生影响,顺向箭头微造型表面表现出了最优的摩擦特性;试件摩擦系数随着转速的增大呈线性增长趋势,随着载荷的增大而减小,减小的幅度随载荷的增大逐渐变得缓慢;表面形貌三维表征参数Ssk、Sku、Vvv、Vvc、Us与摩擦特性均有一定的关联性.展开更多
This paper introduces a novel fiat plate solar collector （FPC） using micro heat pipe array （MHPA） as a key element. To analyze the thermal transfer behavior of flat plate solar collector with micro heat pipe array...This paper introduces a novel fiat plate solar collector （FPC） using micro heat pipe array （MHPA） as a key element. To analyze the thermal transfer behavior of flat plate solar collector with micro heat pipe array （MHPA-FPC）, an indoor experiment for thermal transfer characteristic of MHPA applied to FPC was conducted by using an electrical heating film to simulate the solar radiation. Different cooling water flow rates, cooling water temperatures, slopes, and contact thermal resistances be- tween the condenser of MHPA and the heat exchanger were tested at different heating powers. The experimental results in- dicate that MHPA-FPC exhibits the enhanced heat transfer capability with increased cooling water flow rate and temperature. Total thermal resistance has a maximum decline of approximately 10% when the flow rate increases from 180 to 360 L h-1 and 38% when the cooling water temperature increases from 20~C to 40~C. When the inclination angle of MHPA-FPC ex- ceeds 30~, the slope change has a negligible effect on the heat transfer performance of MHPA-FPC. In addition, contact thermal resistance significantly affects the heat transfer capability of MHPA-FPC. The total thermal resistances lowers to nearly half of the original level when contact material between the condenser of MHPA and the heat exchanger changes from conductive silicone to conductive grease. These results could provide useful information for the optimal design and operation of MHPA-FPC.展开更多
The technique of micro-electrolysis-contact oxidization was exploited to treat chitin-producing wastewater. Results showed that Fe-C micro-electrolysis can remove about 30% CODcr, raise pH from 0.7 to 5.5. The CODcr r...The technique of micro-electrolysis-contact oxidization was exploited to treat chitin-producing wastewater. Results showed that Fe-C micro-electrolysis can remove about 30% CODcr, raise pH from 0.7 to 5.5. The CODcr removal efficiency by biochemical process can be more than 80%. During a half year抯 operation, the whole system worked very stably and had good results, as proved by the fact that every quality indicator of effluent met the expected discharge stan-dards; which means that chitin wastewater can be treated by the technique of micro-electrolysis, contact oxidization.展开更多
A ZnO micro/nanowire has been utilized to fabricate Schottky-contacted humidity sensors based on a metal-semiconductor-metal （M-S-M） structure. By means of the piezotronic effect, the signal level, sensitivity and s...A ZnO micro/nanowire has been utilized to fabricate Schottky-contacted humidity sensors based on a metal-semiconductor-metal （M-S-M） structure. By means of the piezotronic effect, the signal level, sensitivity and sensing resolution of the humidity sensor were significantly enhanced when applying an external strain. Since a higher Schottky barrier markedly reduces the signal level, while a lower Schottky barrier decreases the sensor sensitivity due to increased ohmic transport, a 0.22% compressive strain was found to optimize the performance of the humidity sensor, with the largest responsivity being 1,240%. The physical mechanism behind the observed mechanical-electrical behavior was carefully studied by using band structure diagrams. This work provides a promising way to significantly enhance the overall performance of a Schottky-contact structured micro/nanowire sensor.展开更多
To study the effect of electrolytic concentration,bioactive ceramic films containing Ca and P on the surface of the Ti6Al4V alloy were prepared by micro-arc oxidation(MAO) in aqueous solutions of different concentrati...To study the effect of electrolytic concentration,bioactive ceramic films containing Ca and P on the surface of the Ti6Al4V alloy were prepared by micro-arc oxidation(MAO) in aqueous solutions of different concentrations.Composition,micro-morphology,wettability of the films and their corrosion behavior in a Hank's SBF were studied.Our experimental results show that the film is mainly composed of anatase,rutile and amorphous phases.With an increase in electrolytic concentration,the ratio of rutile in films enlarge and small amounts of calcium phosphate(Ca3(PO4)2) and hydroxyapatite(HA) appear.The number of micropores in films increases but their dimensions decrease and their porosities increase slightly.As the surface roughness of MAO film increases with concentration,the wettablility of the oxide film improves continually,while micro-hardness increases at first and then decreases.MAO treatment clearly improves the corrosion resistance of substrates in a Hank's SBF.展开更多
This paper aims to characterize the hydrophobic property of shark-skin-inspired riblets with potential engineering appli- cations. Based on the hydrophobic theory, a new hydrophobic model which is consistent with the ...This paper aims to characterize the hydrophobic property of shark-skin-inspired riblets with potential engineering appli- cations. Based on the hydrophobic theory, a new hydrophobic model which is consistent with the special structure of shark-skin-inspired micro-riblets was proposed. Then, the contact angles of different droplets were measured by optical contact angle measuring device on the shark-skin-inspired micro-riblets and the smooth surface, respectively. The results show that the surface of micro-riblets possesses obvious hydrophobicity, and the actual contact angles of different droplets residing on the riblets decrease with the increase in the droplet volume. According to the new hydrophobic model and the measurement of contact angle, it was found that the arrangement and structure of the shark-skin-inspired micro-riblets significantly affect the surface hydrophobic property. Using the new hydrophobic model, the prediction error of contact angle can be less than 3% compared with the measured one. The research on hydrophobic property of biomimetic micro-riblets is proved to be necessary and important to well explain drag reduction and microbe-resistant property of micro-riblets.展开更多
文摘为了研究表面形貌对线接触弹流状态下摩擦副摩擦特性的影响,采用激光微造型技术,通过控制微造型的形状、深度、间距和面积占有率等参数制造了两组表面高度算术平均值Sa分别相同的试件.使用Talysurf CCI Lite非接触式三维光学轮廓仪对表面进行测量,采用ISO25178参数及连通性系数Us对测量表面进行表征,最后在JPM-1型双盘摩擦磨损试验机上对试件进行富油摩擦试验,得到不同转速、不同载荷工况下的摩擦系数.结果表明:线接触状态下,微造型形状、方向及深度均会对表面的摩擦特性产生影响,顺向箭头微造型表面表现出了最优的摩擦特性;试件摩擦系数随着转速的增大呈线性增长趋势,随着载荷的增大而减小,减小的幅度随载荷的增大逐渐变得缓慢;表面形貌三维表征参数Ssk、Sku、Vvv、Vvc、Us与摩擦特性均有一定的关联性.
基金financially supported by the Natural Science Foundation of Beijing(Grant No.Z1004020201201)the Opening Funds of State Key Laboratory of Building Safety and Build Environment of China(Grant No.BSBE 2011-07)
文摘This paper introduces a novel fiat plate solar collector （FPC） using micro heat pipe array （MHPA） as a key element. To analyze the thermal transfer behavior of flat plate solar collector with micro heat pipe array （MHPA-FPC）, an indoor experiment for thermal transfer characteristic of MHPA applied to FPC was conducted by using an electrical heating film to simulate the solar radiation. Different cooling water flow rates, cooling water temperatures, slopes, and contact thermal resistances be- tween the condenser of MHPA and the heat exchanger were tested at different heating powers. The experimental results in- dicate that MHPA-FPC exhibits the enhanced heat transfer capability with increased cooling water flow rate and temperature. Total thermal resistance has a maximum decline of approximately 10% when the flow rate increases from 180 to 360 L h-1 and 38% when the cooling water temperature increases from 20~C to 40~C. When the inclination angle of MHPA-FPC ex- ceeds 30~, the slope change has a negligible effect on the heat transfer performance of MHPA-FPC. In addition, contact thermal resistance significantly affects the heat transfer capability of MHPA-FPC. The total thermal resistances lowers to nearly half of the original level when contact material between the condenser of MHPA and the heat exchanger changes from conductive silicone to conductive grease. These results could provide useful information for the optimal design and operation of MHPA-FPC.
文摘The technique of micro-electrolysis-contact oxidization was exploited to treat chitin-producing wastewater. Results showed that Fe-C micro-electrolysis can remove about 30% CODcr, raise pH from 0.7 to 5.5. The CODcr removal efficiency by biochemical process can be more than 80%. During a half year抯 operation, the whole system worked very stably and had good results, as proved by the fact that every quality indicator of effluent met the expected discharge stan-dards; which means that chitin wastewater can be treated by the technique of micro-electrolysis, contact oxidization.
文摘A ZnO micro/nanowire has been utilized to fabricate Schottky-contacted humidity sensors based on a metal-semiconductor-metal （M-S-M） structure. By means of the piezotronic effect, the signal level, sensitivity and sensing resolution of the humidity sensor were significantly enhanced when applying an external strain. Since a higher Schottky barrier markedly reduces the signal level, while a lower Schottky barrier decreases the sensor sensitivity due to increased ohmic transport, a 0.22% compressive strain was found to optimize the performance of the humidity sensor, with the largest responsivity being 1,240%. The physical mechanism behind the observed mechanical-electrical behavior was carefully studied by using band structure diagrams. This work provides a promising way to significantly enhance the overall performance of a Schottky-contact structured micro/nanowire sensor.
基金Projects 50535050 supported by the National Natural Science Foundation of ChinaNCET-06-0479 by the Program for New Century Excellent Talents in University of China
文摘To study the effect of electrolytic concentration,bioactive ceramic films containing Ca and P on the surface of the Ti6Al4V alloy were prepared by micro-arc oxidation(MAO) in aqueous solutions of different concentrations.Composition,micro-morphology,wettability of the films and their corrosion behavior in a Hank's SBF were studied.Our experimental results show that the film is mainly composed of anatase,rutile and amorphous phases.With an increase in electrolytic concentration,the ratio of rutile in films enlarge and small amounts of calcium phosphate(Ca3(PO4)2) and hydroxyapatite(HA) appear.The number of micropores in films increases but their dimensions decrease and their porosities increase slightly.As the surface roughness of MAO film increases with concentration,the wettablility of the oxide film improves continually,while micro-hardness increases at first and then decreases.MAO treatment clearly improves the corrosion resistance of substrates in a Hank's SBF.
基金Acknowledgment This work was supported by the National Natural Science Foundation of China （NSFC）, NO. 51275071.
文摘This paper aims to characterize the hydrophobic property of shark-skin-inspired riblets with potential engineering appli- cations. Based on the hydrophobic theory, a new hydrophobic model which is consistent with the special structure of shark-skin-inspired micro-riblets was proposed. Then, the contact angles of different droplets were measured by optical contact angle measuring device on the shark-skin-inspired micro-riblets and the smooth surface, respectively. The results show that the surface of micro-riblets possesses obvious hydrophobicity, and the actual contact angles of different droplets residing on the riblets decrease with the increase in the droplet volume. According to the new hydrophobic model and the measurement of contact angle, it was found that the arrangement and structure of the shark-skin-inspired micro-riblets significantly affect the surface hydrophobic property. Using the new hydrophobic model, the prediction error of contact angle can be less than 3% compared with the measured one. The research on hydrophobic property of biomimetic micro-riblets is proved to be necessary and important to well explain drag reduction and microbe-resistant property of micro-riblets.
