The Nd2Fe14B grain growth behavior in sintered Nd-Fe-B magnets was quantitatively described.The effects of sintering temperature and time,and alloy powder size and its distribution on grain growth process were analyze...The Nd2Fe14B grain growth behavior in sintered Nd-Fe-B magnets was quantitatively described.The effects of sintering temperature and time,and alloy powder size and its distribution on grain growth process were analyzed.Hence,possible grain growth mechanisms in these magnets were qualitatively discussed.The Nd2Fe14B grain growth proceeded at quite a high rate in the initial 0~1 h of sintering and from then onwards the grain growth rate decreased.A large average particle size or a wide particle size distribution of initial alloy powders was found to remarkably accelerate the grain growth process and even result in the occurrence of abnormal grain growth.On the basis of experimental results,two grain growth mechanisms were considered to operate during sintering of Nd-Fe-B magnets,that is,dissolution and re-precipitation of Nd2Fe14B particles,and Nd2Fe14B particle growth by coalescence.It was believed that Nd2Fe14B particle growth by coalescence not only produced a large average grain size and a wide grain size distribution,but also was the fundamental reason for the formation of abnormally large grains in the microstructure of sintered Nd-Fe-B magnets.展开更多
It is still a challenge to simultaneously enhance coercivity(H_(cj))and remanence(J_(r))of hot-deformed Nd-Fe-B magnet due to the coercivity-remanence trade-off dilemma.Here,we achieved this balance between H_(cj)and ...It is still a challenge to simultaneously enhance coercivity(H_(cj))and remanence(J_(r))of hot-deformed Nd-Fe-B magnet due to the coercivity-remanence trade-off dilemma.Here,we achieved this balance between H_(cj)and Jr by flake Cu powder assisted DyF_(3)interflake addition.The Hcj increases from 1218 to 1496 kA/m and Jr increases from 1.32 to 1.34 T compared with the original magnet.Results show that the width of coarse grain layers reduces because of the introduction of flake Cu,which increases the contact areas of the adjacent grains at ribbon interfaces and suppresses the excessive growth of grains.The stronger degree of texture and higher density compared with the original magnet should take the responsibility for the increase of J_(r).Additionally,the aggregation regions of rare earth rich(RE-rich)phase reduce and the betterment of the microstructure is another reason for the enhancement of Jr in the flake Cu aided DyF_(3)hot-deformed magnet.This strategy of using flake powder additives provides a promising method for optimizing microstructure and enhancing magnetic properties of hot-deformed Nd-Fe-B magnets.展开更多
基于不同氧化物与碳的结合能不同,与碳的还原反应在不同的分析条件下具有先后次序,用脉冲红外氧化物夹杂分析仪,对4μm的烧结Nd Fe B永磁材料粉末的氧化行为进行了方法研究。实验结果表明,通过合理设置参数,选用跟踪升温模式,可以快速分...基于不同氧化物与碳的结合能不同,与碳的还原反应在不同的分析条件下具有先后次序,用脉冲红外氧化物夹杂分析仪,对4μm的烧结Nd Fe B永磁材料粉末的氧化行为进行了方法研究。实验结果表明,通过合理设置参数,选用跟踪升温模式,可以快速分离Nd Fe B永磁材料粉末中的不同氧化物,并可以通过加权方法进行定性验证。展开更多
The double-alloy powder mixed method is very proper for developing new small-mass products by changing the composi- tion of sintered Nd-Fe-B magnets, and there is little research on this aspect. The variation on magne...The double-alloy powder mixed method is very proper for developing new small-mass products by changing the composi- tion of sintered Nd-Fe-B magnets, and there is little research on this aspect. The variation on magnetic and mechanical properties of high intrinsic coercivity Nd-Fe-B magnets prepared by double-alloy powder mixed method was discussed, which is a method blend- ing two-type main phase alloy powders with different components. The results showed that the intrinsic coercivity and density of sin- tered Nd-Fe-B magnets increased gradually with the increase in Dy content, and the double-alloy powder mixed method could obtain high intrinsic coercivity Nd-Fe-B magnets with good crystallographic alignment and microstructure. The bending strength of sintered Nd-Fe-B magnets declined, and the Rockwell hardness of sintered Nd-Fe-B magnets first declined, and then increased with the in- crease in Dy content. The microstructure showed that there existed the phenomenon that the Dy element diffused into main phase dur- ing sintering process, and the distribution of Dy content in main phase had some variation in homogeneity as a result of incomplete reaction between the double-alloy powder types.展开更多
基金Project supported by China National Development Plan for Key Fundamental Research(973)(G2000-67201-3)
文摘The Nd2Fe14B grain growth behavior in sintered Nd-Fe-B magnets was quantitatively described.The effects of sintering temperature and time,and alloy powder size and its distribution on grain growth process were analyzed.Hence,possible grain growth mechanisms in these magnets were qualitatively discussed.The Nd2Fe14B grain growth proceeded at quite a high rate in the initial 0~1 h of sintering and from then onwards the grain growth rate decreased.A large average particle size or a wide particle size distribution of initial alloy powders was found to remarkably accelerate the grain growth process and even result in the occurrence of abnormal grain growth.On the basis of experimental results,two grain growth mechanisms were considered to operate during sintering of Nd-Fe-B magnets,that is,dissolution and re-precipitation of Nd2Fe14B particles,and Nd2Fe14B particle growth by coalescence.It was believed that Nd2Fe14B particle growth by coalescence not only produced a large average grain size and a wide grain size distribution,but also was the fundamental reason for the formation of abnormally large grains in the microstructure of sintered Nd-Fe-B magnets.
基金Project supported by the National Key Research and Development Program of China(2022YFB3505201,2022YFB3505400)the National Natural Science Foundation of China(52261034)the Natural Science Foundation of Jiangxi Province(20224BAB204015)。
文摘It is still a challenge to simultaneously enhance coercivity(H_(cj))and remanence(J_(r))of hot-deformed Nd-Fe-B magnet due to the coercivity-remanence trade-off dilemma.Here,we achieved this balance between H_(cj)and Jr by flake Cu powder assisted DyF_(3)interflake addition.The Hcj increases from 1218 to 1496 kA/m and Jr increases from 1.32 to 1.34 T compared with the original magnet.Results show that the width of coarse grain layers reduces because of the introduction of flake Cu,which increases the contact areas of the adjacent grains at ribbon interfaces and suppresses the excessive growth of grains.The stronger degree of texture and higher density compared with the original magnet should take the responsibility for the increase of J_(r).Additionally,the aggregation regions of rare earth rich(RE-rich)phase reduce and the betterment of the microstructure is another reason for the enhancement of Jr in the flake Cu aided DyF_(3)hot-deformed magnet.This strategy of using flake powder additives provides a promising method for optimizing microstructure and enhancing magnetic properties of hot-deformed Nd-Fe-B magnets.
基金National Natural Science Foundation of China(51274039)State Key Laboratory for Advanced Metals and Materials(2010Z-09)Research Fund for 2012 Doctoral Program of Higher Education(20120006110007)
文摘基于不同氧化物与碳的结合能不同,与碳的还原反应在不同的分析条件下具有先后次序,用脉冲红外氧化物夹杂分析仪,对4μm的烧结Nd Fe B永磁材料粉末的氧化行为进行了方法研究。实验结果表明,通过合理设置参数,选用跟踪升温模式,可以快速分离Nd Fe B永磁材料粉末中的不同氧化物,并可以通过加权方法进行定性验证。
基金Project supported by the Natural Science Foundation of Hubei Province(2014CFB626,2015CFC785)the Research Project of Hubei Provincial Department of Education(D20151801)the Opening Foundation of Hubei Key Laboratory of Automotive Power Train and Electronic Control(ZDK1201404)
文摘The double-alloy powder mixed method is very proper for developing new small-mass products by changing the composi- tion of sintered Nd-Fe-B magnets, and there is little research on this aspect. The variation on magnetic and mechanical properties of high intrinsic coercivity Nd-Fe-B magnets prepared by double-alloy powder mixed method was discussed, which is a method blend- ing two-type main phase alloy powders with different components. The results showed that the intrinsic coercivity and density of sin- tered Nd-Fe-B magnets increased gradually with the increase in Dy content, and the double-alloy powder mixed method could obtain high intrinsic coercivity Nd-Fe-B magnets with good crystallographic alignment and microstructure. The bending strength of sintered Nd-Fe-B magnets declined, and the Rockwell hardness of sintered Nd-Fe-B magnets first declined, and then increased with the in- crease in Dy content. The microstructure showed that there existed the phenomenon that the Dy element diffused into main phase dur- ing sintering process, and the distribution of Dy content in main phase had some variation in homogeneity as a result of incomplete reaction between the double-alloy powder types.
