The dissolution and diffusion of CO_(2)in oil and water and its displacement mechanism were investigated by laboratory experiment and numerical simulation for Block 9 in the Tahe oilfield,a sandstone oil reservoir wit...The dissolution and diffusion of CO_(2)in oil and water and its displacement mechanism were investigated by laboratory experiment and numerical simulation for Block 9 in the Tahe oilfield,a sandstone oil reservoir with strong bottom-water drive in Tarim Basin,Northwest China.Such parameters were analyzed as solubility ratio of CO_(2)in oil,gas and water,interfacial tension,in-situ oil viscosity distribution,remaining oil saturation distribution,and oil compositions.The results show that CO_(2)flooding could control water coning and increase oil production.In the early stage of the injection process,CO_(2)expanded vertically due to gravity differentiation,and extended laterally under the action of strong bottom water in the intermediate and late stages.The CO_(2)got enriched and extended at the oil-water interface,forming a high interfacial tension zone,which inhibited the coning of bottom water to some extent.A miscible region with low interfacial tension formed at the gas injection front,which reduced the in-situ oil viscosity by about 50%.The numerical simulation results show that enhanced oil recovery(EOR)is estimated at 5.72%and the oil exchange ratio of CO_(2)is 0.17 t/t.展开更多
In the presence of bottom water, a drop in the reservoir pressure due to fluid production causes the aquifer water to expand and to flow into the reservoir. Therefore, hydrocarbon production from a well is limited by ...In the presence of bottom water, a drop in the reservoir pressure due to fluid production causes the aquifer water to expand and to flow into the reservoir. Therefore, hydrocarbon production from a well is limited by the critical flow rate. The main purpose of this study is to investigate the breakthrough time and the critical rate by using a novel 3-D horizontal well model. Based on the hypothesis that the horizontal well is located in any position of a circular reservoir with no-flow boundary on the top of the reservoir and constant pressure boundary at the bottom, the horizontal well has been regarded as an infinite conductivity line sink and then a 3-D steady-state flow model of the horizontal well is set up. A point sink pressure solution can be obtained with the Fourier transform. The result of the pressure distribution of the uniform flux horizontal well can be presented by means of the principle of superposition. According to the stable water cresting theory, this study confirms the stable height of water cresting and the critical rate. Meanwhile, it can re-confirm the breakthrough time at a specific rate. The output of a comparison between this 3-D model and the reservoir numerical simulator （Eclipse） shows the method presented here can be applied to investigate the behavior of a water cresting and to predict the breakthrough time at the bottom water driver reservoir.展开更多
It is well-known that barriers have a significant impact on the production performance of horizontal wells developed in a bottom water drive reservoir. In most cases, reservoir barriers are semi-permeable. Based on pr...It is well-known that barriers have a significant impact on the production performance of horizontal wells developed in a bottom water drive reservoir. In most cases, reservoir barriers are semi-permeable. Based on previous research on impermeable reservoir barrier, a mathematical flow model was derived for a horizontal well of a bottom water drive reservoir with a semi-permeable barrier. Besides, analytical equations were also presented to calculate critical parameters, such as production rate,pressure and potential difference. The effects of barrier, well and reservoir parameters on our model results were further investigated.The results show that the larger the barrier size is or the higher the barrier location is, the higher the critical production rate and potential difference of a horizontal well are. When the barrier permeability equals the formation permeability or the barrier width equals zero, the critical production rates converge to the values same to that of the case with no barrier. When the barrier permeability equals zero, the problem is regarded as a case of impermeable barrier. This model can be applied to predicting horizontal wells' critical production parameters in reservoirs with semi-permeable barriers.展开更多
The Triassic massive sandstone reservoir in the Tahe oilfield has a strong bottom-water drive and is characterized by great burial depth,high temperature and salinity,a thin pay zone,and strong heterogeneity.At presen...The Triassic massive sandstone reservoir in the Tahe oilfield has a strong bottom-water drive and is characterized by great burial depth,high temperature and salinity,a thin pay zone,and strong heterogeneity.At present,the water-cut is high in each block within the reservoir;some wells are at an ultrahigh water-cut stage.A lack of effective measures to control water-cut rise and stabilize oil production have necessitated the application of enhanced oil recovery(EOR)technology.This paper investigates the development and technological advances for oil reservoirs with strong edge/bottom-water drive globally,and compares their application to reservoirs with characteristics similar to the Tahe oilfield.Among the technological advances,gas injection from the top and along the direction of structural dip has been used to optimize the flow field in a typical bottom-water drive reservoir.Bottom-water coning is restrained by gas injection-assisted water control.In addition,increasing the lateral driving pressure differential improves the plane sweep efficiency which enhances oil recovery in turn.Gas injection technology in combination with technological measures like channeling prevention and blocking,and water plugging and profile control,can achieve better results in reservoir development.Gas flooding tests in the Tahe oilfield are of great significance to identifying which EOR technology is the most effective and has the potential of large-scale application for improving development of deep reservoirs with a strong bottomwater drive.展开更多
Bottom hole temperatures (BHTs) and static formation temperatures (DSTs) of 70 deep exploratory wells are used to evaluate the geothermal regime in the northeastern part of Sirt Basin. A linear regression was derived ...Bottom hole temperatures (BHTs) and static formation temperatures (DSTs) of 70 deep exploratory wells are used to evaluate the geothermal regime in the northeastern part of Sirt Basin. A linear regression was derived between the BHT’s and the DST’s, for correcting the bottom hole temperatures from the drilling factors that lower them from the true formation temperatures. The geothermal gradients were calculated using the corrected BHT’s and the heat flow has been estimated. Interpretation of the geothermal data, utilizing subsurface maps and isothermal geologic cross section, revealed a shallow, local semi-thermal reservoir of Oligo-Miocene age (at depths 1000 m). The geothermal gradients and heat flow values of this reservoir are ranging from 40 - >60°C/Km and from 80 up to >130 mW/m2, respectively. At deeper depths (>1000 m until the maximum depth of investigation), the area has more or less moderate to low geothermal gradients that range from 40 to 2. The study indicates that the vertical and the lateral variations of the formation temperatures, geothermal gradients and the heat flow values are controlled by the structural, groundwater movements as well as lithological and thermal characteristics of the subsurface sequence.展开更多
文摘The dissolution and diffusion of CO_(2)in oil and water and its displacement mechanism were investigated by laboratory experiment and numerical simulation for Block 9 in the Tahe oilfield,a sandstone oil reservoir with strong bottom-water drive in Tarim Basin,Northwest China.Such parameters were analyzed as solubility ratio of CO_(2)in oil,gas and water,interfacial tension,in-situ oil viscosity distribution,remaining oil saturation distribution,and oil compositions.The results show that CO_(2)flooding could control water coning and increase oil production.In the early stage of the injection process,CO_(2)expanded vertically due to gravity differentiation,and extended laterally under the action of strong bottom water in the intermediate and late stages.The CO_(2)got enriched and extended at the oil-water interface,forming a high interfacial tension zone,which inhibited the coning of bottom water to some extent.A miscible region with low interfacial tension formed at the gas injection front,which reduced the in-situ oil viscosity by about 50%.The numerical simulation results show that enhanced oil recovery(EOR)is estimated at 5.72%and the oil exchange ratio of CO_(2)is 0.17 t/t.
文摘In the presence of bottom water, a drop in the reservoir pressure due to fluid production causes the aquifer water to expand and to flow into the reservoir. Therefore, hydrocarbon production from a well is limited by the critical flow rate. The main purpose of this study is to investigate the breakthrough time and the critical rate by using a novel 3-D horizontal well model. Based on the hypothesis that the horizontal well is located in any position of a circular reservoir with no-flow boundary on the top of the reservoir and constant pressure boundary at the bottom, the horizontal well has been regarded as an infinite conductivity line sink and then a 3-D steady-state flow model of the horizontal well is set up. A point sink pressure solution can be obtained with the Fourier transform. The result of the pressure distribution of the uniform flux horizontal well can be presented by means of the principle of superposition. According to the stable water cresting theory, this study confirms the stable height of water cresting and the critical rate. Meanwhile, it can re-confirm the breakthrough time at a specific rate. The output of a comparison between this 3-D model and the reservoir numerical simulator （Eclipse） shows the method presented here can be applied to investigate the behavior of a water cresting and to predict the breakthrough time at the bottom water driver reservoir.
基金Project(51404201)supported by the National Natural Science Foundation of ChinaProject(2011ZX05024-003)supported by the National Science and Technology Major Project of China+1 种基金Project(14ZB0045)supported by the Scientific Project of Sichuan Provincial Education Department,ChinaProject(2015JY0076)supported by Basic Application Research of Science and Technology Department of Sichuan Province,China
文摘It is well-known that barriers have a significant impact on the production performance of horizontal wells developed in a bottom water drive reservoir. In most cases, reservoir barriers are semi-permeable. Based on previous research on impermeable reservoir barrier, a mathematical flow model was derived for a horizontal well of a bottom water drive reservoir with a semi-permeable barrier. Besides, analytical equations were also presented to calculate critical parameters, such as production rate,pressure and potential difference. The effects of barrier, well and reservoir parameters on our model results were further investigated.The results show that the larger the barrier size is or the higher the barrier location is, the higher the critical production rate and potential difference of a horizontal well are. When the barrier permeability equals the formation permeability or the barrier width equals zero, the critical production rates converge to the values same to that of the case with no barrier. When the barrier permeability equals zero, the problem is regarded as a case of impermeable barrier. This model can be applied to predicting horizontal wells' critical production parameters in reservoirs with semi-permeable barriers.
文摘The Triassic massive sandstone reservoir in the Tahe oilfield has a strong bottom-water drive and is characterized by great burial depth,high temperature and salinity,a thin pay zone,and strong heterogeneity.At present,the water-cut is high in each block within the reservoir;some wells are at an ultrahigh water-cut stage.A lack of effective measures to control water-cut rise and stabilize oil production have necessitated the application of enhanced oil recovery(EOR)technology.This paper investigates the development and technological advances for oil reservoirs with strong edge/bottom-water drive globally,and compares their application to reservoirs with characteristics similar to the Tahe oilfield.Among the technological advances,gas injection from the top and along the direction of structural dip has been used to optimize the flow field in a typical bottom-water drive reservoir.Bottom-water coning is restrained by gas injection-assisted water control.In addition,increasing the lateral driving pressure differential improves the plane sweep efficiency which enhances oil recovery in turn.Gas injection technology in combination with technological measures like channeling prevention and blocking,and water plugging and profile control,can achieve better results in reservoir development.Gas flooding tests in the Tahe oilfield are of great significance to identifying which EOR technology is the most effective and has the potential of large-scale application for improving development of deep reservoirs with a strong bottomwater drive.
文摘Bottom hole temperatures (BHTs) and static formation temperatures (DSTs) of 70 deep exploratory wells are used to evaluate the geothermal regime in the northeastern part of Sirt Basin. A linear regression was derived between the BHT’s and the DST’s, for correcting the bottom hole temperatures from the drilling factors that lower them from the true formation temperatures. The geothermal gradients were calculated using the corrected BHT’s and the heat flow has been estimated. Interpretation of the geothermal data, utilizing subsurface maps and isothermal geologic cross section, revealed a shallow, local semi-thermal reservoir of Oligo-Miocene age (at depths 1000 m). The geothermal gradients and heat flow values of this reservoir are ranging from 40 - >60°C/Km and from 80 up to >130 mW/m2, respectively. At deeper depths (>1000 m until the maximum depth of investigation), the area has more or less moderate to low geothermal gradients that range from 40 to 2. The study indicates that the vertical and the lateral variations of the formation temperatures, geothermal gradients and the heat flow values are controlled by the structural, groundwater movements as well as lithological and thermal characteristics of the subsurface sequence.
