摘要
针对线结构光测量系统中如何提高光刀中心位置提取精度的问题,根据系统量传递理论,建立了线结构光截面强度的偏态分布分析模型,采用一种基于重心法的自适应迭代算法来提取光刀中心位置,并且分析了被曲面调制后的光刀强度分布变化对光刀中心位置提取精度的影响.分别对45°标准斜面和自由曲面进行了实验,并与阈值重心法、自适应阈值法进行了比较.实验结果表明,自适应迭代提取算法可以得到较稳定、更准确的光刀中心位置数据,精度可从50μm提高到10μm左右,并具有受外界干扰影响较小的特点,因此满足了线结构光测量系统的测量精度要求.
Aiming at improving the precision o（ extracting the center position ot the light stripe of the linear light measurement system, an abnormal distributing model of energy of light stripe section is established, where a self-adaptive iterative algorithmic is developed to extract the center position of the light stripe based on the centrobaric method. The modulated influence on the distribution of energy of light stripe resulting from the measured object surface is investigated. The tests with standard bevel of 45^o and the free surface are conducted respectively. Compared with the center position gotten by centrobaric method and self-adaptive threshold method, it is found that the proposed method enables to extract the light stripe center position exactly and steadily to outperform with a precision of 10 μm and higher anti-interference capacity.
出处
《西安交通大学学报》
EI
CAS
CSCD
北大核心
2007年第1期73-76,共4页
Journal of Xi'an Jiaotong University
基金
国家自然科学基金资助项目(50575178
50535030)
陕西省自然科学基金资助项目(2004E232)
关键词
线结构光
偏态分布
自适应迭代
linear-structured light stripe
abnormal distribution
self-adaptive iterative
